lkml.org 
[lkml]   [2015]   [Mar]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 4/4] regulator: qcom: Rework to single platform device
On Tue 03 Mar 14:09 PST 2015, Stephen Boyd wrote:

> On 03/02/15 20:25, Bjorn Andersson wrote:
> > - config.of_node = pdev->dev.of_node;
> > +static int rpm_reg_probe(struct platform_device *pdev)
> > +{
> > + const struct rpm_regulator_data *reg;
> > + const struct of_device_id *match;
> > + struct regulator_config config = { };
> > + struct regulator_dev *rdev;
> > + struct qcom_rpm_reg *vreg;
> >
> > - ret = rpm_reg_of_parse(pdev->dev.of_node, &vreg->desc,
> > - &config, initdata);
> > - if (ret)
> > - return ret;
> > + match = of_match_device(rpm_of_match, &pdev->dev);
> > + for (reg = match->data; reg->name; reg++) {
>
> How does this work for the case where we may not want to add all the
> regulators that a PMIC supports. I'm mostly thinking about the case
> where we want to use the pm8xxx-regulator driver for a few regulators
> and so we omit them from the DT for the RPM regulators.
>

An empty or non-existing regulator of_node will still be registered, but
without REGULATOR_CHANGE_STATUS nor REGULATOR_CHANGE_VOLTAGE; so any
operation on this regulator will fail with an -EPERM.

Regards,
Bjorn


\
 
 \ /
  Last update: 2015-03-03 23:41    [W:0.170 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site