Messages in this thread | | | Date | Tue, 03 Mar 2015 09:10:15 +0100 | From | Gregory CLEMENT <> | Subject | Re: [PATCH v4 2/2] ARM: mvebu: a385-db-ap: Enable the NAND |
| |
Hi Maxime,
On 18/02/2015 11:32, Maxime Ripard wrote: > The Armada 385 Access Point Development Board has a 1GB NAND SLC chip from > Micron as its main storage. Enable it.
I wanted applying your patch but it failed. Actually it depends on your other patch "ARM: mvebu: armada-385-ap: Enable USB3 port" and this patch depend on an other patch "usb: xhci: plat: Add USB phy support" which hadn't been merged.
So either you send a new version which apply on 4.0-rc1, or we can wait for that "usb: xhci: plat: Add USB phy support" will be merged then I will be able applying "ARM: mvebu: armada-385-ap: Enable USB3 port" and finally this patch. As you want.
Thanks,
Gregory
> > Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> > --- > arch/arm/boot/dts/armada-385-db-ap.dts | 13 +++++++++++++ > 1 file changed, 13 insertions(+) > > diff --git a/arch/arm/boot/dts/armada-385-db-ap.dts b/arch/arm/boot/dts/armada-385-db-ap.dts > index b891b4c897f5..ee648fb19075 100644 > --- a/arch/arm/boot/dts/armada-385-db-ap.dts > +++ b/arch/arm/boot/dts/armada-385-db-ap.dts > @@ -130,6 +130,19 @@ > phy-mode = "rgmii-id"; > }; > > + nfc: flash@d0000 { > + status = "okay"; > + #address-cells = <1>; > + #size-cells = <1>; > + > + num-cs = <1>; > + nand-ecc-strength = <4>; > + nand-ecc-step-size = <512>; > + marvell,nand-keep-config; > + marvell,nand-enable-arbiter; > + nand-on-flash-bbt; > + }; > + > usb3@f0000 { > status = "okay"; > usb-phy = <&usb3_phy>; >
-- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com
| |