Messages in this thread | | | Date | Wed, 25 Mar 2015 21:42:02 +0100 | From | Pavel Machek <> | Subject | Re: [Gta04-owner] [PATCH 3/3] tty/slaves: add a driver to power on/off UART attached devices. |
| |
Hi!
> > In the case of our GPS, it receives control over the serial connection from > > the UART, > > Ahem - does it? > > AFAIK the chip simply starts to emit NMEA records if powered on. There is no > command going over the serial interface to address it or control it.
Well _most_ GPSes enable you to control them over the serial line. (Things like sampling rate, AGPS data upload, ...)
> > I think the GPS is “primarily" a uart-attached device. > > But not in the same way as an I2C device. > > Especially the serial interface is not a bus and not used for signalling and > power control. It is payload data (only).
Serial interface looks a lot like a (point-to-point) bus to me. Similar to SATA, for example. Pavel -- (english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
| |