lkml.org 
[lkml]   [2015]   [Mar]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 2/3] leds: ktd2692: add device tree bindings for ktd2692
On 03/25/2015 07:00 AM, Ingi Kim wrote:
> This patch adds the device tree bindings for ktd2692 flash LEDs.
> Add optional properties 'flash-timeout-us' to control flash timeout
> and 'vin-supply' for flash-led regulator
>
> Signed-off-by: Ingi Kim <ingi2.kim@samsung.com>
> ---
> .../devicetree/bindings/leds/leds-ktd2692.txt | 33 ++++++++++++++++++++++
> 1 file changed, 33 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>
> diff --git a/Documentation/devicetree/bindings/leds/leds-ktd2692.txt b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
> new file mode 100644
> index 0000000..f78512f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
> @@ -0,0 +1,33 @@
> +* Kinetic Technologies - KTD2692 Flash LED Driver
> +
> +KTD2692 is the ideal power solution for high-power flash LEDs.
> +It uses ExpressWire single-wire programming for maximum flexibility.
> +
> +The ExpressWire interface through CTRL pin can control LED on/off and
> +enable/disable the IC, Movie(max 1/3 of Flash current) / Flash mode current,
> +Flash timeout, LVP(low voltage protection).
> +
> +Also, When the AUX pin is pulled high while CTRL pin is high,
> +LED current will be ramped up to the flash-mode current level.
> +
> +Required properties:
> + - compatible: "kinetic,ktd2692"
> + - ctrl-gpio, aux-gpio : gpio pins in order control ktd2692 flash led.
> + There is an internal 300kOhm pull-down resistor at each pin
> + - vin-supply : "vin" LED supply (2.7V to 5.5V)
> + See Documentation/devicetree/bindings/regulator/regulator.txt
> +

Above bindings are not that readable to me. Remove the tab spaces before properties.

> +Optional property:
> + - flash-timeout-us : Maximum flash timeout in microseconds.
> + flash timeout ranges from 0 to 1835000us and
> + default is 1049000us.
> +
> +Example:
> +
> +flash-led {
> + compatible = "kinetic,ktd2692";
> + ctrl-gpio = <&gpc0 1 0>;
> + aux-gpio = <&gpc0 2 0>;
> + flash-timeout-us = <1835000>;
> + vin-supply = <&vbat>;
> +};


--
Varka Bhadram



\
 
 \ /
  Last update: 2015-03-25 04:41    [W:0.155 / U:0.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site