Messages in this thread | | | Date | Wed, 18 Mar 2015 18:46:39 +0530 | Subject | Re: [PATCH] net: macb: fix endian code for avr32 | From | Arun Chandran <> |
| |
On Wed, Mar 18, 2015 at 4:27 PM, Ben Dooks <ben.dooks@codethink.co.uk> wrote: > > [note this has yet to be compile tested on avr32] > > The changes to run the macb driver in 29af05aeb98e ("net: macb:
Yes I mistakenly thought zynq board was the first to run it in BIG endian mode.
> Add big endian CPU support") to support big endian operation on > ARM may not work on AVR32 which already is naturally big endian > architecture (and the driver already works here). > > In this case the readl/writel relaxed will do the opposite of __raw > accesors which arleady work. Add an indirection of cdneth_ prefixed > accesors which are changed as necessary. Also do not issue the DMA > descritpor endian fetch configuration for AVR32. > > From discussions with Arnd Bergman, the following fix changes the use > of readl_relaxed and writel_relaxed with a version that can be put > back to __raw_readl/__raw_writel for the CONFIG_AVR32 case (and also > remove the change to the DMA descriptor endian). > > Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk> > Reported-by: Arnd Bergmann <arnd@arndb.de> > -- > CC: Linux Networking List <netdev@vger.kernel.org> > CC: Arun Chandran <achandran@mvista.com> > CC: Haavard Skinnemoen <hskinnemoen@gmail.com> > CC: Hans-Christian Egtvedt <egtvedt@samfundet.no> > CC: Linux Kernel List <linux-kernel@vger.kernel.org> > CC: Nicolas Ferre <nicolas.ferre@atmel.com> > --- > drivers/net/ethernet/cadence/macb.c | 14 +++++++------- > drivers/net/ethernet/cadence/macb.h | 20 ++++++++++++++------ > 2 files changed, 21 insertions(+), 13 deletions(-) > > diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c > index b71e316..1c3f6e7 100644 > --- a/drivers/net/ethernet/cadence/macb.c > +++ b/drivers/net/ethernet/cadence/macb.c > @@ -449,7 +449,7 @@ static void macb_update_stats(struct macb *bp) > WARN_ON((unsigned long)(end - p - 1) != (MACB_TPF - MACB_PFR) / 4); > > for(; p < end; p++, reg++) > - *p += readl_relaxed(reg); > + *p += cdneth_readl(reg); > } > > static int macb_halt_tx(struct macb *bp) > @@ -1587,7 +1587,7 @@ static void macb_configure_dma(struct macb *bp) > dmacfg |= GEM_BIT(TXPBMS) | GEM_BF(RXBMS, -1L); > dmacfg &= ~GEM_BIT(ENDIA_PKT); > /* Tell the chip to byteswap descriptors on big-endian hosts */ > -#ifdef __BIG_ENDIAN
With https://kernel.googlesource.com/pub/scm/linux/kernel/git/davem/net-next/+/62f6924cb1543a10d05150d77f9a5e01e12c9ce1 in net-next I think CONFIG_AVR32 check is not required.
--Arun
| |