lkml.org 
[lkml]   [2015]   [Feb]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v8 2/2] drivers/gpio: Altera soft IP GPIO driver
From
Date
On Wed, 2015-01-14 at 10:58 +0100, Linus Walleij wrote:
> On Wed, Dec 24, 2014 at 9:22 AM, <thloh@altera.com> wrote:
>
> > From: Tien Hock Loh <thloh@altera.com>
> >
> > Adds a new driver for Altera soft GPIO IP. The driver is able to
> > do read/write and allows GPIO to be a interrupt controller.
> >
> > Tested on Altera GHRD on interrupt handling and IO.
> >
> > Signed-off-by: Tien Hock Loh <thloh@altera.com>
>
> (...)
> > +config GPIO_ALTERA
> > + tristate "Altera GPIO"
> > + depends on OF_GPIO
>
> select GPIOLIB_IRQCHIP
>
> Also, I think (see below)
>
> select GENERIC_GPIO
>
> > +#include <linux/gpio.h>
>
> #include <linux/gpio/driver.h>
>
> should be just fine instead of this old header.
>
> > +#include <linux/init.h>
> > +#include <linux/interrupt.h>
> > +#include <linux/io.h>
> > +#include <linux/irq.h>
>
> Should not be needed.
>
> > +#include <linux/irqchip/chained_irq.h>
> > +#include <linux/irqdomain.h>
>
> None of these should be needed.
>
> > +#include <linux/kernel.h>
> > +#include <linux/module.h>
> > +#include <linux/of_irq.h>
> > +#include <linux/of_gpio.h>
> > +#include <linux/platform_device.h>
> > +#include <linux/slab.h>
>
> #include <linux/basic_mmio_gpio.h>
>
> with GENERIC_GPIO (see below).

OK

> > +
> > +#define ALTERA_GPIO_MAX_NGPIO 32
> > +#define ALTERA_GPIO_DATA 0x0
> > +#define ALTERA_GPIO_DIR 0x4
> > +#define ALTERA_GPIO_IRQ_MASK 0x8
> > +#define ALTERA_GPIO_EDGE_CAP 0xc
> > +
> > +/**
> > +* struct altera_gpio_chip
> > +* @mmchip : memory mapped chip structure.
> > +* @gpio_lock : synchronization lock so that new irq/set/get requests
> > + will be blocked until the current one completes.
> > +* @interrupt_trigger : specifies the hardware configured IRQ trigger type
> > + (rising, falling, both, high)
> > +* @mapped_irq : kernel mapped irq number.
> > +*/
> > +struct altera_gpio_chip {
> > + struct of_mm_gpio_chip mmchip;
> > + spinlock_t gpio_lock;
> > + int interrupt_trigger;
> > + int mapped_irq;
> > +};
> > +
> > +static void altera_gpio_irq_unmask(struct irq_data *d)
> > +{
> > + struct altera_gpio_chip *altera_gc;
> > + struct of_mm_gpio_chip *mm_gc;
> > + unsigned long flags;
> > + u32 intmask;
> > +
> > + altera_gc = irq_data_get_irq_chip_data(d);
> > + mm_gc = &altera_gc->mmchip;
> > +
> > + spin_lock_irqsave(&altera_gc->gpio_lock, flags);
> > + intmask = readl(mm_gc->regs + ALTERA_GPIO_IRQ_MASK);
> > + /* Set ALTERA_GPIO_IRQ_MASK bit to unmask */
> > + intmask |= BIT(irqd_to_hwirq(d));
> > + writel(intmask, mm_gc->regs + ALTERA_GPIO_IRQ_MASK);
> > + spin_unlock_irqrestore(&altera_gc->gpio_lock, flags);
> > +}
> > +
> > +static void altera_gpio_irq_mask(struct irq_data *d)
> > +{
> > + struct altera_gpio_chip *altera_gc;
> > + struct of_mm_gpio_chip *mm_gc;
> > + unsigned long flags;
> > + u32 intmask;
> > +
> > + altera_gc = irq_data_get_irq_chip_data(d);
> > + mm_gc = &altera_gc->mmchip;
> > +
> > + spin_lock_irqsave(&altera_gc->gpio_lock, flags);
> > + intmask = readl(mm_gc->regs + ALTERA_GPIO_IRQ_MASK);
> > + /* Clear ALTERA_GPIO_IRQ_MASK bit to mask */
> > + intmask &= ~BIT(irqd_to_hwirq(d));
> > + writel(intmask, mm_gc->regs + ALTERA_GPIO_IRQ_MASK);
> > + spin_unlock_irqrestore(&altera_gc->gpio_lock, flags);
> > +}
> > +
> > +static int altera_gpio_irq_set_type(struct irq_data *d,
> > + unsigned int type)
> > +{
> > + struct altera_gpio_chip *altera_gc = irq_data_get_irq_chip_data(d);
> > +
> > + altera_gc = irq_data_get_irq_chip_data(d);
> > +
> > + if (type == IRQ_TYPE_NONE)
> > + return 0;
> > + if (type == IRQ_TYPE_LEVEL_HIGH &&
> > + altera_gc->interrupt_trigger == IRQ_TYPE_LEVEL_HIGH)
> > + return 0;
> > + if (type == IRQ_TYPE_EDGE_RISING &&
> > + altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_RISING)
> > + return 0;
> > + if (type == IRQ_TYPE_EDGE_FALLING &&
> > + altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_FALLING)
> > + return 0;
> > + if (type == IRQ_TYPE_EDGE_BOTH &&
> > + altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_BOTH)
> > + return 0;
> > +
> > + return -EINVAL;
> > +}
>
> It took me a while to understand this. Write in a comment that
> this is a hardware that is synthesized for a specific trigger
> type, and that there is no way to software-configure the
> trigger type.
>
OK noted.

> > +
> > +static unsigned int altera_gpio_irq_startup(struct irq_data *d)
> > +{
> > + altera_gpio_irq_unmask(d);
> > +
> > + return 0;
> > +}
> > +
> > +static void altera_gpio_irq_shutdown(struct irq_data *d)
> > +{
> > + altera_gpio_irq_mask(d);
> > +}
>
> Instead of those pointless functions just assign
> the unmask/mask functions in the vtable right below.
>
OK

> > +
> > +static struct irq_chip altera_irq_chip = {
> > + .name = "altera-gpio",
> > + .irq_mask = altera_gpio_irq_mask,
> > + .irq_unmask = altera_gpio_irq_unmask,
> > + .irq_set_type = altera_gpio_irq_set_type,
> > + .irq_startup = altera_gpio_irq_startup,
> > + .irq_shutdown = altera_gpio_irq_shutdown,
>
> i.e. here.
>
> > +static int altera_gpio_get(struct gpio_chip *gc, unsigned offset)
> > +{
> > + struct of_mm_gpio_chip *mm_gc;
> > +
> > + mm_gc = to_of_mm_gpio_chip(gc);
> > +
> > + return !!(readl(mm_gc->regs + ALTERA_GPIO_DATA) >> offset);
> > +}
> > +
> > +static void altera_gpio_set(struct gpio_chip *gc, unsigned offset, int value)
> > +{
> > + struct of_mm_gpio_chip *mm_gc;
> > + struct altera_gpio_chip *chip;
> > + unsigned long flags;
> > + unsigned int data_reg;
> > +
> > + mm_gc = to_of_mm_gpio_chip(gc);
> > + chip = container_of(mm_gc, struct altera_gpio_chip, mmchip);
> > +
> > + spin_lock_irqsave(&chip->gpio_lock, flags);
> > + data_reg = readl(mm_gc->regs + ALTERA_GPIO_DATA);
> > + if (value)
> > + data_reg |= BIT(offset);
> > + else
> > + data_reg &= ~BIT(offset);
> > + writel(data_reg, mm_gc->regs + ALTERA_GPIO_DATA);
> > + spin_unlock_irqrestore(&chip->gpio_lock, flags);
> > +}
> > +
> > +static int altera_gpio_direction_input(struct gpio_chip *gc, unsigned offset)
> > +{
> > + struct of_mm_gpio_chip *mm_gc;
> > + struct altera_gpio_chip *chip;
> > + unsigned long flags;
> > + unsigned int gpio_ddr;
> > +
> > + mm_gc = to_of_mm_gpio_chip(gc);
> > + chip = container_of(mm_gc, struct altera_gpio_chip, mmchip);
> > +
> > + spin_lock_irqsave(&chip->gpio_lock, flags);
> > + /* Set pin as input, assumes software controlled IP */
> > + gpio_ddr = readl(mm_gc->regs + ALTERA_GPIO_DIR);
> > + gpio_ddr &= ~BIT(offset);
> > + writel(gpio_ddr, mm_gc->regs + ALTERA_GPIO_DIR);
> > + spin_unlock_irqrestore(&chip->gpio_lock, flags);
> > +
> > + return 0;
> > +}
> > +
> > +static int altera_gpio_direction_output(struct gpio_chip *gc,
> > + unsigned offset, int value)
> > +{
> > + struct of_mm_gpio_chip *mm_gc;
> > + struct altera_gpio_chip *chip;
> > + unsigned long flags;
> > + unsigned int data_reg, gpio_ddr;
> > +
> > + mm_gc = to_of_mm_gpio_chip(gc);
> > + chip = container_of(mm_gc, struct altera_gpio_chip, mmchip);
> > +
> > + spin_lock_irqsave(&chip->gpio_lock, flags);
> > + /* Sets the GPIO value */
> > + data_reg = readl(mm_gc->regs + ALTERA_GPIO_DATA);
> > + if (value)
> > + data_reg |= BIT(offset);
> > + else
> > + data_reg &= ~BIT(offset);
> > + writel(data_reg, mm_gc->regs + ALTERA_GPIO_DATA);
> > +
> > + /* Set pin as output, assumes software controlled IP */
> > + gpio_ddr = readl(mm_gc->regs + ALTERA_GPIO_DIR);
> > + gpio_ddr |= BIT(offset);
> > + writel(gpio_ddr, mm_gc->regs + ALTERA_GPIO_DIR);
> > + spin_unlock_irqrestore(&chip->gpio_lock, flags);
> > +
> > + return 0;
> > +}
>
> These calls seem like pretty vanilla generic GPIO functions.
> Use GENERIC_GPIO with bgpio_init() and override the default
> functions only when really needed.
>
> See e.g. drivers/gpio/gpio-74xx-mmio.c
>
OK, I'll update this.

> > +static int altera_gpio_irq_map(struct irq_domain *h, unsigned int irq,
> > + irq_hw_number_t hw_irq_num)
> > +{
> > + irq_set_chip_data(irq, h->host_data);
> > + irq_set_chip_and_handler(irq, &altera_irq_chip, handle_level_irq);
> > +
> > + return 0;
> > +}
> > +
> > +static const struct irq_domain_ops altera_gpio_irq_ops = {
> > + .map = altera_gpio_irq_map,
> > + .xlate = irq_domain_xlate_onecell,
> > +};
>
> This looks like some leftover garbage. You don't need them with
> GPIOLIB_IRQCHIP so delete these two.
>
OK

> > +static int altera_gpio_remove(struct platform_device *pdev)
> > +{
> > + struct altera_gpio_chip *altera_gc = platform_get_drvdata(pdev);
> > +
> > + gpiochip_remove(&altera_gc->mmchip.gc);
> > +
> > + irq_set_handler_data(altera_gc->mapped_irq, NULL);
> > + irq_set_chained_handler(altera_gc->mapped_irq, NULL);
>
> These two calls should not be needed either.
>
OK

> Yours,
> Linus Walleij

Regards,
Tien Hock Loh


\
 
 \ /
  Last update: 2015-02-06 04:21    [W:0.137 / U:1.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site