lkml.org 
[lkml]   [2015]   [Feb]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH RFC v8 11/21] Documentation: dt-bindings: Add bindings for Synopsys DW MIPI DSI DRM bridge driver
From
Date
Hi Liu,

Am Mittwoch, den 11.02.2015, 15:21 +0800 schrieb Liu Ying:
[...]
> Our internal MIPI DSI SoC owner gave me some feedbacks on the clock sources.
> According to him, the Synopsys DesignWare MIPI DSI host controller needs four
> clock sources from an application platform - pclk, refclk, cfg_clk and dpipclk.
> These clocks are mentioned in the "DesignWare Cores MIPI DSI Host Controller
> Databook, 1.01a1.30a.pdf" documentation.
>
> Quote some words from the documentation:
> pclk - APB clock signal.
> refclk - D-PHY reference clock used for Master-side serial clock generation in
> clock multiplying unit(PLL).
> cfg_clk - D-PHY Configuration clock used for the initialization of the PHY. It
> is also used for exiting ULPS state.
> dpipclk - Input Pixel clock signal.
>
> The below table reflects how does i.MX6Q/DL provide the pclk, refclk and cfg_clk
> for the DesignWare MIPI DSI host controller, according to the SoC owner.
> ----------------------------------------------------------------------------
> | Synopsys | i.MX6Q/DL MIPI DSI |
> | DesignWare |------------------------------------------------------------|
> | documentation | clock | clock root | CCM_CCGR bits |
> |---------------|------------|--------------------|--------------------------|
> | pclk | ips_clk | ipg_clk_root | mipi_core_cfg_clk_enable |
> |---------------|------------|--------------------|--------------------------|
> | refclk | pll_refclk | video_27m_clk_root | mipi_core_cfg_clk_enable |
> |---------------|------------|--------------------|--------------------------|
> | cfg_clk | cfg_clk | video_27m_clk_root | mipi_core_cfg_clk_enable |
> ----------------------------------------------------------------------------
>
> I think we should add a new clock "IMX6QDL_CLK_MIPI_IPG" as a shared clock gate
> clock.

That would be necessary if the pclk clock rate mattered or would be set
anywhere.

> And, the clock-names property should exactly contain "pclk", "refclk"
> and "cfg_clk", right?

My personal preference would be to drop the superfluous "clk" prefix if
the resulting clock name is still clearly relatable to the official
name. Existing clock naming for the pclk is a bit mixed -
The "snps,dw-apb-timer" binding uses "pclk", which seems to be quite
common in other places, too. The "snps,dw-apb-uart" bindings use
"apb_pclk". "snps,dw-hdmi-tx" uses "iahb" and "isfr" without the clk
suffix.
How about "pclk", "ref" and "cfg"?

regards
Philipp



\
 
 \ /
  Last update: 2015-02-11 14:21    [W:0.096 / U:0.364 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site