lkml.org 
[lkml]   [2015]   [Dec]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4.3 004/125] net: bcmgenet: Software reset EPHY after power on
Date
4.3-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Florian Fainelli <f.fainelli@gmail.com>

[ Upstream commit 5dbebbb44a6ad94aab2cd1a46f7676f255403f64 ]

The EPHY on GENET v1->v3 is extremely finicky, and will show occasional
failures based on the timing and reset sequence, ranging from duplicate
packets, to extremely high latencies.

Perform an additional software reset, and re-configuration to make sure it is
in a consistent and working state.

Fixes: 6ac3ce8295e6 ("net: bcmgenet: Remove excessive PHY reset")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/net/ethernet/broadcom/genet/bcmgenet.c | 4 +++-
drivers/net/ethernet/broadcom/genet/bcmgenet.h | 1 +
drivers/net/ethernet/broadcom/genet/bcmmii.c | 18 ++++++++++++++++++
3 files changed, 22 insertions(+), 1 deletion(-)

--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -907,8 +907,10 @@ static void bcmgenet_power_up(struct bcm
}

bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
- if (mode == GENET_POWER_PASSIVE)
+ if (mode == GENET_POWER_PASSIVE) {
bcmgenet_phy_power_set(priv->dev, true);
+ bcmgenet_mii_reset(priv->dev);
+ }
}

/* ioctl handle special commands that are not present in ethtool. */
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.h
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.h
@@ -674,6 +674,7 @@ int bcmgenet_mii_init(struct net_device
int bcmgenet_mii_config(struct net_device *dev);
int bcmgenet_mii_probe(struct net_device *dev);
void bcmgenet_mii_exit(struct net_device *dev);
+void bcmgenet_mii_reset(struct net_device *dev);
void bcmgenet_phy_power_set(struct net_device *dev, bool enable);
void bcmgenet_mii_setup(struct net_device *dev);

--- a/drivers/net/ethernet/broadcom/genet/bcmmii.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmmii.c
@@ -163,6 +163,7 @@ void bcmgenet_mii_setup(struct net_devic
phy_print_status(phydev);
}

+
static int bcmgenet_fixed_phy_link_update(struct net_device *dev,
struct fixed_phy_status *status)
{
@@ -172,6 +173,22 @@ static int bcmgenet_fixed_phy_link_updat
return 0;
}

+/* Perform a voluntary PHY software reset, since the EPHY is very finicky about
+ * not doing it and will start corrupting packets
+ */
+void bcmgenet_mii_reset(struct net_device *dev)
+{
+ struct bcmgenet_priv *priv = netdev_priv(dev);
+
+ if (GENET_IS_V4(priv))
+ return;
+
+ if (priv->phydev) {
+ phy_init_hw(priv->phydev);
+ phy_start_aneg(priv->phydev);
+ }
+}
+
void bcmgenet_phy_power_set(struct net_device *dev, bool enable)
{
struct bcmgenet_priv *priv = netdev_priv(dev);
@@ -214,6 +231,7 @@ static void bcmgenet_internal_phy_setup(
reg = bcmgenet_ext_readl(priv, EXT_EXT_PWR_MGMT);
reg |= EXT_PWR_DN_EN_LD;
bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
+ bcmgenet_mii_reset(dev);
}

static void bcmgenet_moca_phy_setup(struct bcmgenet_priv *priv)



\
 
 \ /
  Last update: 2015-12-07 17:01    [W:1.535 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site