lkml.org 
[lkml]   [2015]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] RTC: RK808: Work around hardware bug on November 31st
From
Chris,

On Sun, Dec 6, 2015 at 5:33 PM, Chris Zhong <zyw@rock-chips.com> wrote:
> Hi Doug
>
> RK808 has a shadowed register for saving a "frozen" RTC time.
> When we setting "GET_TIME" to 1, the time will save in this shadowed
> register. So if we do not set the "GET_TIME", we always get the last time.
>
> read the old time before "get_time", and then read the time again for new
> time. If the old time earlier than 12.1 && new time later than 12.1, we
> should
> +1 day for the correct rtc time.
>
> On the other hand, we should set the "GET_TIME" after rk808_rtc_set_time,
> for restore the time before suspend/shut_down.

Ah, good idea using the shadow registers. The whole point of the
shadow registers is to enable atomic read of time, right? So if the
clock ticks as you are reading 23:59:59 you don't end up reading
23:59:00 or 24:59:59 (you'll get either 23:59:59 or 24:00:00). So
right, time read will now be:

1. Read GET_TIME. Confirm it's 1.
2. Read the time.
3. Set GET_TIME to 0.
4. Set GET_TIME to 1.
5. Read the time.

If time from #2 < 11/31 and time from #5 >= 11/31 then we do the
adjust. If GET_TIME wasn't 1 in step #1 then we won't do any
adjusting unless the time is actually 11/31.

Between steps #4 and #5 we'll need to add a small delay since old code
used to use the setting to 0 as a delay (as commented).

We should presumably always leave GET_TIME as 1 unless we're actively
reading the time for the most reliability. Also, if we've already
read the time this bootup, we can certainly optimize the above by
skipping #1 and #2.

-Doug


\
 
 \ /
  Last update: 2015-12-07 04:01    [W:0.080 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site