lkml.org 
[lkml]   [2015]   [Dec]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] Fix CFQ I/O scheduler parameter name in documentation
As seen in block/cfq-iosched.c, the parameter name is low_latency.

Signed-off-by: Libor Pechacek <lpechacek@suse.cz>
---
Documentation/block/cfq-iosched.txt | 15 +++++++--------
1 file changed, 7 insertions(+), 8 deletions(-)

diff --git a/Documentation/block/cfq-iosched.txt b/Documentation/block/cfq-iosched.txt
index f3bc72945cbd..1e4f835a659d 100644
--- a/Documentation/block/cfq-iosched.txt
+++ b/Documentation/block/cfq-iosched.txt
@@ -81,14 +81,13 @@ on higher end storage.

Default value for this parameter is 8ms.

-latency
--------
-This parameter is used to enable/disable the latency mode of the CFQ
-scheduler. If latency mode (called low_latency) is enabled, CFQ tries
-to recompute the slice time for each process based on the target_latency set
-for the system. This favors fairness over throughput. Disabling low
-latency (setting it to 0) ignores target latency, allowing each process in the
-system to get a full time slice.
+low_latency
+-----------
+This parameter is used to enable/disable the low latency mode of the CFQ
+scheduler. If enabled, CFQ tries to recompute the slice time for each process
+based on the target_latency set for the system. This favors fairness over
+throughput. Disabling low latency (setting it to 0) ignores target latency,
+allowing each process in the system to get a full time slice.

By default low latency mode is enabled.

--
1.7.12.4


\
 
 \ /
  Last update: 2015-12-04 10:41    [W:0.603 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site