Messages in this thread | | | Date | Tue, 1 Dec 2015 09:57:27 +0100 | Subject | Re: [PATCH] gpio: Add GPIO support for the ACCES 104-IDI-48 | From | Linus Walleij <> |
| |
On Mon, Nov 23, 2015 at 6:54 PM, William Breathitt Gray <vilhelm.gray@gmail.com> wrote:
> The ACCES 104-IDI-48 family of PC/104 utility boards feature 48 > individually optically isolated digital inputs. Enabled inputs feature > change-of-state detection capability; if change-of-state detection is > enabled, an interrupt is fired off if a change of input level > (low-to-high or high-to-low) is detected. Change-of-state IRQs are > enabled/disabled on 8-bit boundaries, for a total of six boundaries. > > This driver provides GPIO and IRQ support for these 48 channels of > digital input. The base port address for the device may be configured > via the idi_48_base module parameter. The interrupt line number for the > device may be configured via the idi_48_irq module parameter. > > Signed-off-by: William Breathitt Gray <vilhelm.gray@gmail.com>
This is a very nice and clean written driver.
Patch applied.
Yours, Linus Walleij
| |