lkml.org 
[lkml]   [2015]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 0/2] mmc: sdhci: potentially bad behavior when using vmmc supply
On Mon, Nov 09, 2015 at 10:38:03AM +0100, Ulf Hansson wrote:
> [...]
>
> >> > Is the regulator-gpio usage the right thing to do for vqmmc? In my case it is
> >> > not really driven by a gpio but by a pio from the sdhci device. In the binding,
> >>
> >> What's a "pio"?
> >>
> >> What do you mean by the it's driven from the sdhci device?
> >>
> >
> > Sorry I mean sdhci device from the SoC point of view, I should say
> > controller. So yes the signal is driven by the controller.
> >
> >> Is it the internal HW logic of the sdhci controller that manages the
> >> IO voltage? And this logic can be controlled via certain register bits
> >> in the SDHCI controller?
> >>
> >
> > Yes, it depends of the value of the '1.8V Signaling Enable' value in the
> > host control 2 register.
> >
> >> > declaring the gpio is an option so I thought using this regulator fits my need.
> >>
> >> In quite many cases it makes sense to model this though a gpio
> >> regulator. For example when you use a level shifter circuit. Those
> >> normally have gpio pin routed to control the voltage level output for
> >> the signals. For example switching between 1.8V and 2.9V.
> >>
> >
> > I agree, my concern is to know if I can consider it as a 'general' pio
> > since it is driven by the sdhci controller.
>
> This doesn't seems like a case where a gpio regulator should be used
> and I am not sure what problem it would solve. Beside to suppress the
> log warnings (actually those aren't warnings but informations).
>
> Isn't sdhci_do_start_signal_voltage_switch() doing what you need here?
>

It is. I am only wondering the best way to describe the hardware:
- No regulator but I have the 'no vqmmc regulator not found' message which
is a bit annoying and which can be interpreted as an issue for someone
who has no knowledge about this stuff.
- Describe the regulator since there is one on my board. But it is not a
fixed regulator and even if it's close to a gpio one it is not.

Regards

Ludovic


\
 
 \ /
  Last update: 2015-11-09 11:41    [W:0.054 / U:0.560 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site