Messages in this thread Patch in this message | | | From | MaJun <> | Subject | [PATCH v8 1/4] dt-binding:Documents of the mbigen bindings | Date | Fri, 6 Nov 2015 16:28:39 +0800 |
| |
From: Ma Jun <majun258@huawei.com>
Add the mbigen msi interrupt controller bindings document.
This patch based on Mark Rutland's patch https://lkml.org/lkml/2015/7/23/558
Signed-off-by: Ma Jun <majun258@huawei.com> --- Documentation/devicetree/bindings/arm/mbigen.txt | 63 ++++++++++++++++++++++ 1 files changed, 63 insertions(+), 0 deletions(-) create mode 100644 Documentation/devicetree/bindings/arm/mbigen.txt
diff --git a/Documentation/devicetree/bindings/arm/mbigen.txt b/Documentation/devicetree/bindings/arm/mbigen.txt new file mode 100644 index 0000000..eb9a7fd --- /dev/null +++ b/Documentation/devicetree/bindings/arm/mbigen.txt @@ -0,0 +1,63 @@ +Hisilicon mbigen device tree bindings. +======================================= + +Mbigen means: message based interrupt generator. + +MBI is kind of msi interrupt only used on Non-PCI devices. + +To reduce the wired interrupt number connected to GIC, +Hisilicon designed mbigen to collect and generate interrupt. + + +Non-pci devices can connect to mbigen and generate the +interrupt by writing ITS register. + +The mbigen chip and devices connect to mbigen have the following properties: + +Mbigen main node required properties: +------------------------------------------- +- compatible: Should be "hisilicon,mbigen-v2" +- reg: Specifies the base physical address and size of the Mbigen + registers. +- interrupt controller: Identifies the node as an interrupt controller +- msi-parent: This property has two cells. + The 1st cell specifies the ITS this device connected. + The 2nd cell specifies the device id. +- nr-msis:Specifies the total number of interrupt this device has. +- #interrupt-cells : Specifies the number of cells needed to encode an + interrupt source. The value is 2 now. + + The 1st cell is global hardware pin number of the interrupt. + This value depends on the Soc design. + The 2nd cell is the interrupt trigger type. + +Examples: + + mbigen_device_gmac:intc { + compatible = "hisilicon,mbigen-v2"; + reg = <0x0 0xc0080000 0x0 0x10000>; + interrupt-controller; + msi-parent = <&its_dsa 0x40b1c>; + num-msis = <9>; + #interrupt-cells = <2>; + }; + +Devices connect to mbigen required properties: +---------------------------------------------------- +-interrupt-parent: Specifies the mbigen device node which device connected. +-interrupts:specifies the interrupt source. + The 1st cell is global hardware pin number of the interrupt. + This value depends on the Soc design. + The 2nd cell is the interrupt trigger type + +Examples: + gmac0: ethernet@c2080000 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0 0xc2080000 0 0x20000>, + <0 0xc0000000 0 0x1000>; + interrupt-parent = <&mbigen_device_gmac>; + interrupts = <656 1>, + <657 1>; + }; + -- 1.7.1
| |