lkml.org 
[lkml]   [2015]   [Nov]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 6/6] extcon: arizona: Update DT binding documentation for jack detection
Date
Add additional bindings for both inverting the polarity of the jack
detection pins and allowing the use of a second jack detection pin. Note
that the second jack detection pin is hard wired in the chip so can only
be enabled through the binding, rather than a pin being specified.

Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Reviewed-by: Chanwoo Choi <cw00.choi@samsung.com>
---
.../devicetree/bindings/extcon/extcon-arizona.txt | 6 ++++++
1 files changed, 6 insertions(+), 0 deletions(-)

diff --git a/Documentation/devicetree/bindings/extcon/extcon-arizona.txt b/Documentation/devicetree/bindings/extcon/extcon-arizona.txt
index d661811..7640a35 100644
--- a/Documentation/devicetree/bindings/extcon/extcon-arizona.txt
+++ b/Documentation/devicetree/bindings/extcon/extcon-arizona.txt
@@ -14,6 +14,12 @@ Optional properties:
If this node is not mentioned or if the value is unknown, then
headphone detection mode is set to HPDETL.

+ - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack
+ detection.
+ - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for
+ jack detection.
+ - wlf,jd-invert : Invert the polarity of the jack detection switch
+
- wlf,micd-software-compare : Use a software comparison to determine mic
presence
- wlf,micd-detect-debounce : Additional software microphone detection
--
1.7.2.5


\
 
 \ /
  Last update: 2015-11-19 17:21    [W:1.240 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site