[lkml]   [2015]   [Nov]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 07/71] ncr5380: Split NCR5380_init() into two functions
On 11/18/2015 09:35 AM, Finn Thain wrote:
> This patch splits the NCR5380_init() function into two parts, similar
> to the scheme used with atari_NCR5380.c. This avoids two problems.
> Firstly, NCR5380_init() may perform a bus reset, which would cause the
> chip to assert IRQ. The chip is unable to mask its bus reset interrupt.
> Drivers can't call request_irq() before calling NCR5380_init(), because
> initialization must happen before the interrupt handler executes. If
> driver initialization causes an interrupt it may be problematic on some
> platforms. To avoid that, first move the bus reset code into
> NCR5380_maybe_reset_bus().
> Secondly, NCR5380_init() contains some board-specific interrupt setup code
> for the NCR53C400 that does not belong in the core driver. In moving this
> code, better not re-order interrupt initialization and bus reset. Again,
> the solution is to move the bus reset code into NCR5380_maybe_reset_bus().
> Signed-off-by: Finn Thain <>
Reviewed-by: Hannes Reinecke <>


Dr. Hannes Reinecke zSeries & Storage +49 911 74053 688
SUSE LINUX GmbH, Maxfeldstr. 5, 90409 Nürnberg
GF: F. Imendörffer, J. Smithard, J. Guild, D. Upmanyu, G. Norton
HRB 21284 (AG Nürnberg)

 \ /
  Last update: 2015-11-19 14:41    [W:0.379 / U:9.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site