lkml.org 
[lkml]   [2015]   [Nov]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
SubjectRe: [PATCH 1/2] dl2k: Add support for IP1000A-based cards
From
On Sun, Nov 15, 2015 at 12:05 AM, Ondrej Zary
<linux@rainbow-software.org> wrote:
> Add support for IP1000A chips to dl2k driver.
> IP1000A chip looks like a TC9020 with integrated PHY.
>
> This allows IP1000A chips to work reliably because the ipg driver is
> buggy - it loses packets under load and then completely stops
> transmitting data.
>
> Tested with Asus NX1101 v2.0 at 10, 100 and 1000Mbps.
> Also verified that it does not break D-Link DGE-550T.
>
> Signed-off-by: Ondrej Zary <linux@rainbow-software.org>

Nitpicks below.

> --- a/drivers/net/ethernet/dlink/dl2k.c
> +++ b/drivers/net/ethernet/dlink/dl2k.c
> @@ -253,6 +253,18 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
> if (err)
> goto err_out_unmap_rx;
>
> + if (np->chip_id == CHIP_IP1000A &&
> + (np->pdev->revision == 0x40 || np->pdev->revision == 0x41)) {
> + /* PHY magic taken from ipg driver */
> + mii_write(dev, np->phy_addr, 31, 0x0001);
> + mii_write(dev, np->phy_addr, 27, 0x01e0);
> + mii_write(dev, np->phy_addr, 31, 0x0002);
> + mii_write(dev, np->phy_addr, 27, 0xeb8e);
> + mii_write(dev, np->phy_addr, 31, 0x0000);
> + mii_write(dev, np->phy_addr, 30, 0x005e);
> + mii_write(dev, np->phy_addr, 9, 0x0700);

Isn't too many magic numbers?

> + }
> +
> /* Fiber device? */
> np->phy_media = (dr16(ASICCtrl) & PhyMedia) ? 1 : 0;
> np->link_status = 0;
> @@ -361,6 +373,11 @@ parse_eeprom (struct net_device *dev)
> for (i = 0; i < 6; i++)
> dev->dev_addr[i] = psrom->mac_addr[i];
>
> + if (np->chip_id == CHIP_IP1000A) {
> + np->led_mode = psrom->led_mode;
> + return 0;
> + }
> +
> if (np->pdev->vendor != PCI_VENDOR_ID_DLINK) {
> return 0;
> }
> @@ -406,6 +423,28 @@ parse_eeprom (struct net_device *dev)
> return 0;
> }
>
> +static void rio_set_led_mode(struct net_device *dev)
> +{
> + struct netdev_private *np = netdev_priv(dev);
> + void __iomem *ioaddr = np->ioaddr;
> + u32 mode;
> +
> + if (np->chip_id != CHIP_IP1000A)
> + return;
> +
> + mode = dr32(ASICCtrl);
> + mode &= ~(IPG_AC_LED_MODE_BIT_1 | IPG_AC_LED_MODE | IPG_AC_LED_SPEED);
> +
> + if ((np->led_mode & 0x03) > 1)

Isn't "& 0x03) > 1" the same as plain "& 0x02"?

> + mode |= IPG_AC_LED_MODE_BIT_1;
> + if ((np->led_mode & 0x01) == 1)

Hmm… Seems redundant == 1.

> + mode |= IPG_AC_LED_MODE;
> + if ((np->led_mode & 0x08) == 8)

Similar here.

> + mode |= IPG_AC_LED_SPEED;
> +
> + dw32(ASICCtrl, mode);
> +}
> +
> static int
> rio_open (struct net_device *dev)
> {
> @@ -424,6 +463,8 @@ rio_open (struct net_device *dev)
> GlobalReset | DMAReset | FIFOReset | NetworkReset | HostReset);
> mdelay(10);
>
> + rio_set_led_mode(dev);
> +
> /* DebugCtrl bit 4, 5, 9 must set */
> dw32(DebugCtrl, dr32(DebugCtrl) | 0x0230);
>
> @@ -433,9 +474,10 @@ rio_open (struct net_device *dev)
>
> alloc_list (dev);
>
> - /* Get station address */
> - for (i = 0; i < 6; i++)
> - dw8(StationAddr0 + i, dev->dev_addr[i]);
> + /* Set station address */
> + for (i = 0; i < 3; i++)
> + dw16(StationAddr0 + 2 * i,
> + cpu_to_le16(((u16 *)dev->dev_addr)[i]));

Is it specific requirement for new HW? If not, may be another patch
with micro optimizations.

>
> set_multicast (dev);
> if (np->coalesce) {
> @@ -780,6 +822,7 @@ tx_error (struct net_device *dev, int tx_status)
> break;
> mdelay (1);
> }
> + rio_set_led_mode(dev);
> rio_free_tx (dev, 1);
> /* Reset TFDListPtr */
> dw32(TFDListPtr0, np->tx_ring_dma +
> @@ -799,6 +842,7 @@ tx_error (struct net_device *dev, int tx_status)
> break;
> mdelay (1);
> }
> + rio_set_led_mode(dev);
> /* Let TxStartThresh stay default value */
> }
> /* Maximum Collisions */
> @@ -965,6 +1009,7 @@ rio_error (struct net_device *dev, int int_status)
> dev->name, int_status);
> dw16(ASICCtrl + 2, GlobalReset | HostReset);
> mdelay (500);
> + rio_set_led_mode(dev);
> }
> }
>
> diff --git a/drivers/net/ethernet/dlink/dl2k.h b/drivers/net/ethernet/dlink/dl2k.h
> index 23c07b0..8f4f612 100644
> --- a/drivers/net/ethernet/dlink/dl2k.h
> +++ b/drivers/net/ethernet/dlink/dl2k.h
> @@ -211,6 +211,10 @@ enum ASICCtrl_HiWord_bits {
> ResetBusy = 0x0400,
> };
>
> +#define IPG_AC_LED_MODE BIT(14)
> +#define IPG_AC_LED_SPEED BIT(27)
> +#define IPG_AC_LED_MODE_BIT_1 BIT(29)
> +
> /* Transmit Frame Control bits */
> enum TFC_bits {
> DwordAlign = 0x00000000,
> @@ -332,7 +336,10 @@ typedef struct t_SROM {
> u16 asic_ctrl; /* 0x02 */
> u16 sub_vendor_id; /* 0x04 */
> u16 sub_system_id; /* 0x06 */
> - u16 reserved1[12]; /* 0x08-0x1f */
> + u16 pci_base_1; /* 0x08 (IP1000A only) */
> + u16 pci_base_2; /* 0x0a (IP1000A only) */
> + u16 led_mode; /* 0x0c (IP1000A only) */
> + u16 reserved1[9]; /* 0x0e-0x1f */
> u8 mac_addr[6]; /* 0x20-0x25 */
> u8 reserved2[10]; /* 0x26-0x2f */
> u8 sib[204]; /* 0x30-0xfb */
> @@ -397,6 +404,7 @@ struct netdev_private {
> u16 advertising; /* NWay media advertisement */
> u16 negotiate; /* Negotiated media */
> int phy_addr; /* PHY addresses. */
> + u16 led_mode; /* LED mode read from EEPROM (IP1000A only) */
> };
>
> /* The station address location in the EEPROM. */
> @@ -407,10 +415,15 @@ struct netdev_private {
> class_mask of the class are honored during the comparison.
> driver_data Data private to the driver.
> */
> +#define CHIP_IP1000A 1
>
> static const struct pci_device_id rio_pci_tbl[] = {
> {0x1186, 0x4000, PCI_ANY_ID, PCI_ANY_ID, },
> {0x13f0, 0x1021, PCI_ANY_ID, PCI_ANY_ID, },
> + { PCI_VDEVICE(SUNDANCE, 0x1023), CHIP_IP1000A },
> + { PCI_VDEVICE(SUNDANCE, 0x2021), CHIP_IP1000A },
> + { PCI_VDEVICE(DLINK, 0x9021), CHIP_IP1000A },
> + { PCI_VDEVICE(DLINK, 0x4020), CHIP_IP1000A },
> { }
> };
> MODULE_DEVICE_TABLE (pci, rio_pci_tbl);
> --
> Ondrej Zary
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/



--
With Best Regards,
Andy Shevchenko


\
 
 \ /
  Last update: 2015-11-15 03:41    [W:0.078 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site