lkml.org 
[lkml]   [2015]   [Oct]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/4] serial: tegra: Handle another RX race condition
Date
Commit 853a699739fe ("serial: tegra: handle race condition on uart rx
side") attempted to fix a race condition between the RX end of
transmission interrupt and RX DMA completion callback. Despite this
fix there is still another case where these two paths can race and
result in duplicated data. The race condition is as follows:

1. DMA completion interrupt occurs and schedules tasklet to call DMA
callback.
2. DMA callback for the UART driver starts to execute. This will copy
the data from the DMA buffer and restart the DMA. This is done under
uart port spinlock.
3. During the callback, UART interrupt is raised for end of receive. The
UART ISR runs and waits to acquire port spinlock held by the DMA
callback.
4. DMA callback gives up spinlock after copying the data, but before
restarting DMA.
5. UART ISR acquires the spin lock and reads the same DMA buffer because
DMA has not been restarted yet.

The release of the spinlock during the DMA callback was introduced by
commit 9b88748b362c ("tty: serial: tegra: drop uart_port->lock before
calling tty_flip_buffer_push()") to fix a spinlock lock-up issue when
calling tty_flip_buffer_push(). However, since then commit a9c3f68f3cd8
("tty: Fix low_latency BUG") migrated tty_flip_buffer_push() to always
use a workqueue, allowing tty_flip_buffer_push() to be called from
within atomic sections. Therefore, we can remove the unlocking of the
spinlock from the DMA callback and UART ISR and this will ensure that
the race condition no longer occurs.

Reported-by: Christopher Freeman <cfreeman@nvidia.com>
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
---
drivers/tty/serial/serial-tegra.c | 10 ++--------
1 file changed, 2 insertions(+), 8 deletions(-)

diff --git a/drivers/tty/serial/serial-tegra.c b/drivers/tty/serial/serial-tegra.c
index cf0133ae762d..38b49f447bd7 100644
--- a/drivers/tty/serial/serial-tegra.c
+++ b/drivers/tty/serial/serial-tegra.c
@@ -607,9 +607,7 @@ static void tegra_uart_rx_dma_complete(void *args)

tegra_uart_handle_rx_pio(tup, port);
if (tty) {
- spin_unlock_irqrestore(&u->lock, flags);
tty_flip_buffer_push(port);
- spin_lock_irqsave(&u->lock, flags);
tty_kref_put(tty);
}
tegra_uart_start_rx_dma(tup);
@@ -622,13 +620,11 @@ done:
spin_unlock_irqrestore(&u->lock, flags);
}

-static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup,
- unsigned long *flags)
+static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup)
{
struct dma_tx_state state;
struct tty_struct *tty = tty_port_tty_get(&tup->uport.state->port);
struct tty_port *port = &tup->uport.state->port;
- struct uart_port *u = &tup->uport;
unsigned int count;

/* Deactivate flow control to stop sender */
@@ -645,9 +641,7 @@ static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup,

tegra_uart_handle_rx_pio(tup, port);
if (tty) {
- spin_unlock_irqrestore(&u->lock, *flags);
tty_flip_buffer_push(port);
- spin_lock_irqsave(&u->lock, *flags);
tty_kref_put(tty);
}
tegra_uart_start_rx_dma(tup);
@@ -714,7 +708,7 @@ static irqreturn_t tegra_uart_isr(int irq, void *data)
iir = tegra_uart_read(tup, UART_IIR);
if (iir & UART_IIR_NO_INT) {
if (is_rx_int) {
- tegra_uart_handle_rx_dma(tup, &flags);
+ tegra_uart_handle_rx_dma(tup);
if (tup->rx_in_progress) {
ier = tup->ier_shadow;
ier |= (UART_IER_RLSI | UART_IER_RTOIE |
--
2.1.4


\
 
 \ /
  Last update: 2015-10-09 16:21    [W:0.045 / U:0.236 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site