lkml.org 
[lkml]   [2015]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH V6 1/3] Add DT bindings documentation for hi6220 SoC reset controller.
From
Date
Hi,

A few small issues remaining.

Am Donnerstag, den 29.10.2015, 20:55 +0800 schrieb Chen Feng:
> docs: dts: Added documentation for hi6220 Reset Controller

Better to switch the description and the Subject of the e-mail.
Actually, the subject line and patch description already was fine in V4.
Prefixes like "reset: ..." and "dt-bindings: ..." should be in the
subject instead of the commit message body.

> Signed-off-by: Chen Feng <puck.chen@hisilicon.com>
> ---
> .../bindings/reset/hisilicon,hi6220-reset.txt | 32 ++++++++++++++++++++++
> 1 file changed, 32 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/reset/hisilicon,hi6220-reset.txt
>
> diff --git a/Documentation/devicetree/bindings/reset/hisilicon,hi6220-reset.txt b/Documentation/devicetree/bindings/reset/hisilicon,hi6220-reset.txt
> new file mode 100644
> index 0000000..be06352
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/reset/hisilicon,hi6220-reset.txt
> @@ -0,0 +1,32 @@
> +Hisilicon System Reset Controller
> +======================================
> +
> +Please also refer to reset.txt in this directory for common reset
> +controller binding usage.
> +
> +The reset controller registers are part of the system-ctl block on
> +hi6220 SoC.
> +
> +Required properties:
> +- compatible: may be "hisilicon,hi6220-sysctrl"
> +- reg: should be register base and length as documented in the
> + datasheet
> +- #reset-cells: 1, see below
> +
> +Example:
> +sys_ctrl: sys_ctrl@f7030000 {
> + compatible = "hisilicon,hi6220-sysctrl", "syscon";
> + reg = <0x0 0xf7030000 0x0 0x2000>;
> + #clock-cells = <1>;
> + #reset-cells = <1>;
> +};

This example is not indented. That is ok, but the example below is
indented by a tab. Please choose one style for both.

> +
> +Specifying reset lines connected to IP modules
> +==============================================
> +example:

That probably should be "Example:".

> +
> + uart1: uart1@..... {

That should be "uart1: serial@...", as Rob already pointed out.

> + ...
> + resets = <&sys_ctrl 0x305>;

Better use PERIPH_RSTEN3_UART1 instead of 0x305 here.

> + ...
> + };

Also add a pointer to the hisi,hi6220-resets.h here, for example:

A list of valid reset signals can be found in:
include/dt-bindings/reset/hisi,hi6220-resets.h

Also, that header file should be part of this patch, instead of the
driver patch.

best regards
Philipp



\
 
 \ /
  Last update: 2015-10-29 17:21    [W:0.077 / U:0.896 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site