lkml.org 
[lkml]   [2015]   [Oct]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 0/4] Add the OTP gpio pinctrl to fix the TSHUT issue
From
Date
The subject is deleted by my finger.

在 2015年10月20日 17:11, Caesar Wang 写道:
> We need the OTP pin is gpio state before resetting the TSADC controller,
> since the tshut polarity will generate a high signal.
>
> Says:
> The TSHUT temperature is setting more than 80 degree, the default
> tshut polarity is HIGH.
>
> If T > 80C, the OTP output the High Signal.
> If T < 80C, the OTP output the Low Signal.
>
> On the moment, the TSADC controller is reset, the tshut polarity will be
> Low in a short period of time.
>
> So:
> If T < 80C, the OTP output the High Signal.
> If T > 80C, the OTP output the Low Signal.
>
> In some cases, the OTP pin is connected to the PMIC, maybe the PMIC can
> accept the reset response time to avoid this issue.
>
> In other words, the system will be always reboot if we make the OTP pin
> is connected the others IC to control the power.
>
> Tested on box board.
>
>
>
> Caesar Wang (4):
> dt-bindings: Sync the dts to this document
> thermal: rockchip: ensure the otp state before resetting the
> controller
> thermal: rockchip: change the TSHUT default state
> ARM: dts: rockchip: Add the OTP gpio pinctrl
>
> .../bindings/thermal/rockchip-thermal.txt | 5 ++--
> arch/arm/boot/dts/rk3288.dtsi | 9 ++++--
> drivers/thermal/rockchip_thermal.c | 34 +++++++++++++++++++++-
> 3 files changed, 43 insertions(+), 5 deletions(-)
>

--
Thanks,
Caesar



\
 
 \ /
  Last update: 2015-10-20 11:21    [W:0.072 / U:1.328 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site