Messages in this thread | | | Subject | Re: [PATCH 3/4] thermal: rockchip: change the TSHUT default state | From | Caesar Wang <> | Date | Wed, 21 Oct 2015 10:16:55 +0800 |
| |
Doug,
在 2015年10月21日 10:14, Doug Anderson 写道: > Caesar, > > On Tue, Oct 20, 2015 at 6:47 PM, Caesar Wang <caesar.upstream@gmail.com> wrote: >> Doug, >> >> 在 2015年10月21日 00:01, Doug Anderson 写道: >> >> Caesar, >> >> On Tue, Oct 20, 2015 at 2:11 AM, Caesar Wang <wxt@rock-chips.com> wrote: >> >> As the TRM says, the TSHUT default state is high active. >> In general, the TSHUT state can get from the dts. Otherwise >> it gets the state from this. >> >> Can you point at where the TRM says that the default state is high active? >> >> With the manual I have, I look at TSADC_AUTO_CON and I look at the >> description of "Bit 8". It says that "tshut polarity" is 0 for low >> active and 1 for high active. It then said that the Reset Value is 0. >> >> ...the "Reset Value" in tables like this is notoriously unreliable, so >> I can totally believe that it's wrong. If you can point me at the >> part of the TRM that says that TSHUT is high active by default then I >> can confirm that for you. ;) >> >> >> Okay, I know that's my wrong, the polarity is high or low can be selected. >> :-( >> >> I remember the veyron why is the default HiGH active, since the opt is >> connected to the PMIC.(we need think about the devices) >> >> Why is the evb board LOW active, since the opt didn't connected to the >> devices. TSHUT is depend on the CRU to work. > I think we can drop this patch then, right? Any boards that need a > change from the default can just set "rockchip,hw-tshut-polarity", > right? Yep, we should drop this patch. I'm ready resend the patchs.
> -Doug >
-- Thanks, Caesar
| |