lkml.org 
[lkml]   [2015]   [Oct]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 3/4] ARM: multi_v7_defconfig: Enable Maxim 8997 family drivers
From
Date
Hello Krzysztof,

On 10/13/2015 03:18 PM, Krzysztof Kozlowski wrote:
> W dniu 13.10.2015 o 17:36, Javier Martinez Canillas pisze:
>> Hello Krzysztof,
>>
>> On Tue, Oct 13, 2015 at 3:27 AM, Krzysztof Kozlowski
>> <k.kozlowski@samsung.com> wrote:
>>> Enable support for Maxim 8997 Multi Function Device present on Trats and
>>> Origen boards by toggling on drivers: main MFD, charger, haptic motor,
>>> regulator, LED and RTC.
>>>
>>> This allows to test and usage of these boards with multi_v7 config.
>>>
>>> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
>>> ---
>>
>> [snip]
>>
>>> CONFIG_MFD_MAX77686=y
>>> CONFIG_MFD_MAX77693=y
>>> CONFIG_MFD_MAX8907=y
>>> +CONFIG_MFD_MAX8997=y
>>
>> Only slightly related with your patch but some of the MFD driver for
>> PMICs used in Exynos boards (like MAX77686) have a tristate Kconfig
>> symbol while others like this one have a boolean. Do you know if there
>> are any restrictions w.r.t build this as module or is just an
>> arbitrary decision? I'm asking since probably we should either allow
>> this to build as a module or convert the others to boolean.
>
> First, thanks for reviewing the patches.
>

You are welcome.

> As for the question, I wasn't involved in development of these older
> drivers for older boards. I don't know their internals. AFAIK there were
> no specific restrictions, except the usual:
>
> 1. Not all other drivers using resources provided by these, took the
> reference to given resource (e.g. get regulator).
>
> 2. Not all consumer drivers supported deferred probe for given resource
> (e.g. regulator, clock), see: "regulators: max77693: register driver
> earlier to avoid deferred probe". In general USB gadget subsystem has
> this issue. Actually the mentioned max77693 regulator driver should be
> changed from tristate to built-in because of this.
>
> I don't remember any other important issues so if you fix 1 and 2 then
> this can be probably safely switched to modules. Of course after testing.
>

Thanks for the explanation. I neither plan to fix these issues nor changing
these symbols to tristate since I don't have access to the hardware to test.

I asked mostly because I was curious and to know if I should change the MFD
drivers to boolean for the PMIC present in boards I have access, to make it
consistent. But as you said is the other way around, that it would be good
to allow these drivers to be built as a module.

> Best regards,
> Krzysztof
>
> --

Best regards,
--
Javier Martinez Canillas
Open Source Group
Samsung Research America


\
 
 \ /
  Last update: 2015-10-14 10:41    [W:0.124 / U:0.308 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site