lkml.org 
[lkml]   [2015]   [Jan]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH 2/2] HID: i2c-hid: Add support for GPIO interrupts
On Mon, Jan 26, 2015 at 02:37:24PM +0000, Mark Rutland wrote:
> On Mon, Jan 26, 2015 at 02:29:33PM +0000, Mika Westerberg wrote:
> > The HID over I2C specification allows to have the interrupt for a HID
> > device to be GPIO instead of directly connected to the IO-APIC.
> >
> > Add support for this so that when the driver does not find proper interrupt
> > number from the I2C client structure we check if the device has property
> > named "gpios". This is then assumed to be the GPIO that serves as an
> > interrupt for the device.
> >
> > Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
> > ---
> > .../devicetree/bindings/hid/hid-over-i2c.txt | 5 +-
> > drivers/hid/i2c-hid/i2c-hid.c | 70 ++++++++++++++++------
> > 2 files changed, 56 insertions(+), 19 deletions(-)
> >
> > diff --git a/Documentation/devicetree/bindings/hid/hid-over-i2c.txt b/Documentation/devicetree/bindings/hid/hid-over-i2c.txt
> > index 488edcb264c4..8f4a99dad3b9 100644
> > --- a/Documentation/devicetree/bindings/hid/hid-over-i2c.txt
> > +++ b/Documentation/devicetree/bindings/hid/hid-over-i2c.txt
> > @@ -15,7 +15,10 @@ Required properties:
> > - reg: i2c slave address
> > - hid-descr-addr: HID descriptor address
> > - interrupt-parent: the phandle for the interrupt controller
> > -- interrupts: interrupt line
> > +- interrupts: interrupt line if the device uses IO-APIC interrupts
> > +
> > +Optional properties:
> > +- gpios: GPIO used as an interrupt if the device uses GPIO interrupts
>
> Elsewhere we've said that for a GPIO acting as an interrupt line, GPIO
> controller should be marked as an interrupt-controller, and the GPIO
> described as an interrupt line. That also gets you the appropriate
> configuration for the GPIO as an interrupt.
>
> Does this GPIO serve any other purpose than an ersatz interrupt line?

It is just an interrupt.

> If not, it should probably be described as an interrupt. From the PoV of
> this device, it's just an interrupt controller hooked up to the
> interrupt pin.

What I'm trying to do is to get a GPIO that is described in ACPI (as
GpioInt() in _CRS) to be supported in this driver using gpiolib like
this:

desc = gpiod_get(&client->dev, NULL);

This calls to find "gpios" property which ends up finding the GpioInt()
in _CRS.

\
 
 \ /
  Last update: 2015-01-26 16:01    [W:0.448 / U:0.732 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site