lkml.org 
[lkml]   [2015]   [Jan]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/2] NFC: Add ACPI support for NXP PN544
Date
Currently there is no support for ACPI.
This patch uses the following configuration:
- Device id: NXP5440
- Pin mapping:
- 0 IRQ pin
- 1 enable pin
- 2 firmware pin

Signed-off-by: Robert Dolca <robert.dolca@intel.com>
---
drivers/nfc/pn544/i2c.c | 115 ++++++++++++++++++++++++++++++++++++++++++++++--
1 file changed, 112 insertions(+), 3 deletions(-)

diff --git a/drivers/nfc/pn544/i2c.c b/drivers/nfc/pn544/i2c.c
index d9018cd..ae817b0 100644
--- a/drivers/nfc/pn544/i2c.c
+++ b/drivers/nfc/pn544/i2c.c
@@ -24,6 +24,7 @@
#include <linux/gpio.h>
#include <linux/of_gpio.h>
#include <linux/of_irq.h>
+#include <linux/acpi.h>
#include <linux/miscdevice.h>
#include <linux/interrupt.h>
#include <linux/delay.h>
@@ -41,6 +42,11 @@
#define PN544_I2C_FRAME_HEADROOM 1
#define PN544_I2C_FRAME_TAILROOM 2

+/* GPIO names */
+#define PN544_GPIO_NAME_IRQ "pn544_irq"
+#define PN544_GPIO_NAME_FW "pn544_fw"
+#define PN544_GPIO_NAME_EN "pn544_en"
+
/* framing in HCI mode */
#define PN544_HCI_I2C_LLC_LEN 1
#define PN544_HCI_I2C_LLC_CRC 2
@@ -58,6 +64,13 @@ static struct i2c_device_id pn544_hci_i2c_id_table[] = {

MODULE_DEVICE_TABLE(i2c, pn544_hci_i2c_id_table);

+static const struct acpi_device_id pn544_hci_i2c_acpi_match[] = {
+ {"NXP5440", 0},
+ {}
+};
+
+MODULE_DEVICE_TABLE(acpi, pn544_hci_i2c_acpi_match);
+
#define PN544_HCI_I2C_DRIVER_NAME "pn544_hci_i2c"

/*
@@ -861,6 +874,90 @@ exit_state_wait_secure_write_answer:
}
}

+static int pn544_hci_i2c_acpi_request_resources(struct i2c_client *client)
+{
+ struct pn544_i2c_phy *phy = i2c_get_clientdata(client);
+ const struct acpi_device_id *id;
+ struct gpio_desc *gpiod_en, *gpiod_irq, *gpiod_fw;
+ struct device *dev;
+ int ret;
+
+ if (!client)
+ return -EINVAL;
+
+ dev = &client->dev;
+
+ /* Match the struct device against a given list of ACPI IDs */
+ id = acpi_match_device(dev->driver->acpi_match_table, dev);
+
+ if (!id)
+ return -ENODEV;
+
+ /* Get EN GPIO from ACPI */
+ gpiod_en = devm_gpiod_get_index(dev, PN544_GPIO_NAME_EN, 1);
+ if (IS_ERR(gpiod_en)) {
+ nfc_err(dev,
+ "Unable to get EN GPIO\n");
+ return -ENODEV;
+ }
+
+ phy->gpio_en = desc_to_gpio(gpiod_en);
+
+ /* Configuration EN GPIO */
+ ret = gpiod_direction_output(gpiod_en, 0);
+ if (ret) {
+ nfc_err(dev, "Fail EN pin direction\n");
+ return ret;
+ }
+
+ /* Get FW GPIO from ACPI */
+ gpiod_fw = devm_gpiod_get_index(dev, PN544_GPIO_NAME_FW, 2);
+ if (IS_ERR(gpiod_fw)) {
+ nfc_err(dev,
+ "Unable to get FW GPIO\n");
+ return -ENODEV;
+ }
+
+ phy->gpio_fw = desc_to_gpio(gpiod_fw);
+
+ /* Configuration FW GPIO */
+ ret = gpiod_direction_output(gpiod_fw, 0);
+ if (ret) {
+ nfc_err(dev, "Fail FW pin direction\n");
+ return ret;
+ }
+
+ /* Get IRQ GPIO */
+ gpiod_irq = devm_gpiod_get_index(dev, PN544_GPIO_NAME_IRQ, 0);
+ if (IS_ERR(gpiod_irq)) {
+ nfc_err(dev,
+ "Unable to get IRQ GPIO\n");
+ return -ENODEV;
+ }
+
+ phy->gpio_irq = desc_to_gpio(gpiod_irq);
+
+ /* Configure IRQ GPIO */
+ ret = gpiod_direction_input(gpiod_irq);
+ if (ret) {
+ nfc_err(dev, "Fail IRQ pin direction\n");
+ return ret;
+ }
+
+ /* Map the pin to an IRQ */
+ ret = gpiod_to_irq(gpiod_irq);
+ if (ret < 0) {
+ nfc_err(dev, "Fail pin IRQ mapping\n");
+ return ret;
+ }
+
+ nfc_info(dev, "GPIO resource, no:%d irq:%d\n",
+ desc_to_gpio(gpiod_irq), ret);
+ client->irq = ret;
+
+ return 0;
+}
+
#ifdef CONFIG_OF

static int pn544_hci_i2c_of_request_resources(struct i2c_client *client)
@@ -886,7 +983,7 @@ static int pn544_hci_i2c_of_request_resources(struct i2c_client *client)
phy->gpio_en = ret;

/* Configuration of EN GPIO */
- ret = gpio_request(phy->gpio_en, "pn544_en");
+ ret = gpio_request(phy->gpio_en, PN544_GPIO_NAME_EN);
if (ret) {
nfc_err(&client->dev, "Fail EN pin\n");
goto err_dt;
@@ -908,7 +1005,7 @@ static int pn544_hci_i2c_of_request_resources(struct i2c_client *client)
phy->gpio_fw = ret;

/* Configuration of FW GPIO */
- ret = gpio_request(phy->gpio_fw, "pn544_fw");
+ ret = gpio_request(phy->gpio_fw, PN544_GPIO_NAME_FW);
if (ret) {
nfc_err(&client->dev, "Fail FW pin\n");
goto err_gpio_en;
@@ -1003,6 +1100,14 @@ static int pn544_hci_i2c_probe(struct i2c_client *client,
phy->gpio_en = pdata->get_gpio(NFC_GPIO_ENABLE);
phy->gpio_fw = pdata->get_gpio(NFC_GPIO_FW_RESET);
phy->gpio_irq = pdata->get_gpio(NFC_GPIO_IRQ);
+ /* Using ACPI */
+ } else if (ACPI_HANDLE(&client->dev)) {
+ r = pn544_hci_i2c_acpi_request_resources(client);
+ if (r) {
+ nfc_err(&client->dev,
+ "Cannot get ACPI data\n");
+ return r;
+ }
} else {
nfc_err(&client->dev, "No platform data\n");
return -EINVAL;
@@ -1022,9 +1127,12 @@ static int pn544_hci_i2c_probe(struct i2c_client *client,
PN544_I2C_FRAME_HEADROOM, PN544_I2C_FRAME_TAILROOM,
PN544_HCI_I2C_LLC_MAX_PAYLOAD,
pn544_hci_i2c_fw_download, &phy->hdev);
- if (r < 0)
+ if (r < 0) {
+ nfc_err(&client->dev, "HCI Probing error\n");
goto err_hci;
+ }

+ nfc_info(&client->dev, "NFC I2C driver loaded\n");
return 0;

err_hci:
@@ -1082,6 +1190,7 @@ static struct i2c_driver pn544_hci_i2c_driver = {
.name = PN544_HCI_I2C_DRIVER_NAME,
.owner = THIS_MODULE,
.of_match_table = of_match_ptr(of_pn544_i2c_match),
+ .acpi_match_table = ACPI_PTR(pn544_hci_i2c_acpi_match),
},
.probe = pn544_hci_i2c_probe,
.id_table = pn544_hci_i2c_id_table,
--
1.9.1


\
 
 \ /
  Last update: 2015-01-26 12:21    [W:0.091 / U:0.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site