lkml.org 
[lkml]   [2015]   [Jan]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 00/18] spi/xilinx: Speed-up
Date
This set of patches has been developed after using the core to access a spi
nor flash. The initial performance was not as desired. The following changes
have been done.

-This series of patches add driver support for hardware implemented modes:
LSB_FIRS, LOOP and CS_HIGH.

-There is support for irq less operations.

-The buffer size of the core is detected at probe time, speeding up the
operations.

-Code has been simplify and cleaned

This are the results, before and after the patchet

Original
root@qt5022:~# dd if=/dev/mtd0 of=/dev/null
16384+0 records in
16384+0 records out
8388608 bytes (8.4 MB) copied, 117.985 s, 71.1 kB/s

 37:        107      82853  Xilinx INTC Level   1  b0010000.spi-flash

After patchset (irq):
root@qt5022:~# dd if=/dev/mtd0 of=/dev/null
16384+0 records in
16384+0 records out
8388608 bytes (8.4 MB) copied, 49.009 s, 171 kB/s

After patchset (irq):
root@qt5022:~# dd if=/dev/mtd0 of=/dev/null
16384+0 records in
16384+0 records out
8388608 bytes (8.4 MB) copied, 41.2526 s, 203 kB/s

IRQS: ZERO

This set of patches supersedes the previous patchet with only LSB_FIRST and LOOP

Ricardo Ribalda Delgado (18):
spi/xilinx: Support for spi mode LSB_FIRST
spi/xilinx: Support for spi mode LOOP
spi/xilinx: Simplify data read from the Rx FIFO
spi-xilinx: Simplify spi_fill_tx_fifo
spi/xilinx: Leave the IRQ always enabled.
spi/xilinx: Code cleanup
spi/xilinx: Use cached value of register
spi/xilinx: Support cores with no interrupt
spi/xilinx: Do not inhibit transmission in polling mode
spi/xilinx: Support for spi mode CS_HIGH
spi/xilinx: Remove rx_fn and tx_fn pointer
spi/xilinx: Make spi_tx and spi_rx simmetric
spi/xilinx: Convert remainding_bytes in remaining words
spi/xilinx: Convert bits_per_word in bytes_per_word
spi/xilinx: Remove iowrite/ioread wrappers
spi/xilinx: Reset core before buffer_size detection
spi/xilinx: Remove remaining_words driver data variable
spi/xilinx: Check number of slaves range

drivers/spi/spi-xilinx.c | 306 ++++++++++++++++++++++-------------------------
1 file changed, 146 insertions(+), 160 deletions(-)

--
2.1.4



\
 
 \ /
  Last update: 2015-01-23 17:21    [W:0.224 / U:0.460 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site