lkml.org 
[lkml]   [2015]   [Jan]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RESEND v2 3/7] mfd: cros_ec: Add cros_ec_lpc driver for x86 devices
Hello Lee,

On 01/22/2015 11:56 AM, Lee Jones wrote:
>> >
>> Yes, I completely understand your point, is that I didn't think that a ~300
>> lines driver was that bad specially since the communication bits that reads
>> and writes the register is not a complex logic IMHO.
>
> This has nothing to do with LoC, it's the principle of the matter.
>

Ok, got it.

>> >> > Are there any other Low Pin Count drivers in the kernel?
>> >> >
>> >>
>> >> I don't know tbh, I didn't even know what LPC was before I picked this patch
>> >> to push it upstream. I searched in the Linux codebase for other LPC drivers
>> >> but I didn't find anything, that doesn't mean that it doesn't exist though.
>> >
>> > I agree. Perhaps a suitable driver should live in drivers/misc until
>> > there are enough of them to warrant its own subsystem.
>> >
>>
>> Yes, I can move the driver to drivers/misc if you think that is more suitable
>> to be there.
>>
>> I've taken another look and AFAICT there are two other mfd drivers that use an
>> LPC bus, these are drivers/mfd/lpc_{i,s}ch.c for Intel's I/O Controller HUB and
>> System Controller Hub respectively.
>
> These looked like PCI aggregates when I looked at them last?
>

Yes, it seems the LPC bus is behind a PCI bus on these chips. Or at least
that's what I understood on a quick read to the Intel SCH datasheet [0].

Now going back to the Cros EC LPC driver, you are right that this may not
be suitable to drivers/mfd so I'll move it to drivers/misc instead.

Thanks a lot for your feedback.

Best regards,
Javier

[0]: http://www.intel.com/content/www/us/en/intelligent-systems/menlow/sch-datasheet.html


\
 
 \ /
  Last update: 2015-01-22 12:41    [W:2.127 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site