lkml.org 
[lkml]   [2014]   [Sep]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] Documentation: bcm7120-l2: Add Broadcom BCM7120-style L2 binding
On 09/05/2014 01:44 PM, Thomas Gleixner wrote:
> On Fri, 5 Sep 2014, Florian Fainelli wrote:
>> On 09/05/2014 12:21 PM, Thomas Gleixner wrote:
>>> So if I understand correctly what you have is:
>>>
>>> /- GIC------------->
>>> Device-irq ---- [routing]
>>> \- BC irq chip ---->
>>>
>>> and you implement it as
>>>
>>> Device-irq ---- [BC irq chip] ---- [GIC] --->
>>> |
>>> ----------------->
>>>
>>> And the fwd mask is to tell the BC chip to use the GIC and which irq
>>> of the GIC, so it can fiddle with the GIC under the hood, right?
>>
>> The forward mask really is to tell the BCM7120 l2 interrupt controller:
>> bypass me, and output the UART interrupts directly at the GIC level, so
>> I think this does match your understanding.
>>
>> Not setting the forward mask means you would get the UART interrupts at
>> the BCM7120 l2 interrupt controller level, and have to handle them here.
>>
>> Hope this helps clarify what this funky piece of hardware does.
>
> Sigh, this stacked interrupt chip nonsense is becoming a plague.

This is a HW design that we inherited, but fortunately we might be able
to fix that in the future.

>
> So if you set that bit then the UART driver only sees the GIC as its
> interrupt controller and not the L2 thingy. So, the L2 chip only
> enables its interrupt unconditionally for that line and the
> enable/disable happens at the GIC level.

Exactly, this is completely transparent for the UART and the GIC.

>
> If that's the case, that's fine with me. It's not pretty, but at least
> it does not involve L2 fiddling indirectly with the GIC.

Absolutely, we do not have to do the arch_gic_extn thingy.

Thanks for your feedback!
--
Florian


\
 
 \ /
  Last update: 2014-09-05 23:41    [W:0.356 / U:0.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site