lkml.org 
[lkml]   [2014]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: PFUZE100 regulator not going off when PWRON is 0
On Wed, Sep 03, 2014 at 11:44:22AM +0200, Jean-Michel Hautbois wrote:

> I have a custom i.MX6 based board, but PMIC part is exactly the same
> as the Freescale SabreSD board.
> I have a reset button, which makes the PWRON signal on PFUZE100 go from 1 to 0.
> I thought this would reset the chip, and thus all voltages would go to
> 0, but this is not the case. It seems that SWxOMODE registers are
> involved in this process, accorgind to the datasheet, but I don't
> think this is implemented right now.
>
> I also removed regulator-always-on for my SW2 pin in order to get it
> off, but this has no effect.

You should really contact someone who worked on the driver or Freescale
about this - I don't think anyone on the CC list knows anything about
the part. In general if you're asking about a specific driver this is a
good approach. I've CCed Robin Gong who was the original author.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2014-09-03 15:21    [W:0.152 / U:1.432 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site