Messages in this thread | | | Date | Wed, 24 Sep 2014 18:19:06 +0200 | From | Nicolas Ferre <> | Subject | Re: [PATCH] ARM: at91: enable new AIC driver even if the old one is selected |
| |
On 09/09/2014 11:14, Boris BREZILLON : > The new AIC driver is currently only selected when only DT board support > is enabled (and not when both DT and non-DT boards are supported), thus, > when booting a "DT + non-DT" kernel with a dtb, the irqchip is never > initialized/registered which then triggers a panic. > > Signed-off-by: Boris BREZILLON <boris.brezillon@free-electrons.com>
I'm not taking this right now. The Kconfig file is in flux. I'll try to queue it during the 3.18-rc phase.
Bye,
> --- > arch/arm/mach-at91/Kconfig | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/arch/arm/mach-at91/Kconfig b/arch/arm/mach-at91/Kconfig > index 7df2c9b..cd7c0cb 100644 > --- a/arch/arm/mach-at91/Kconfig > +++ b/arch/arm/mach-at91/Kconfig > @@ -51,7 +51,7 @@ config HAVE_AT91_SMD > config SOC_AT91SAM9 > bool > select AT91_SAM9_TIME > - select ATMEL_AIC_IRQ if !OLD_IRQ_AT91 > + select ATMEL_AIC_IRQ > select CPU_ARM926T > select GENERIC_CLOCKEVENTS > > @@ -111,7 +111,7 @@ endif > if SOC_SAM_V4_V5 > config SOC_AT91RM9200 > bool "AT91RM9200" > - select ATMEL_AIC_IRQ if !OLD_IRQ_AT91 > + select ATMEL_AIC_IRQ > select CPU_ARM920T > select GENERIC_CLOCKEVENTS > select HAVE_AT91_DBGU0 >
-- Nicolas Ferre
| |