[lkml]   [2014]   [Aug]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2 1/1] Input: atmel_mxt_ts - Get IRQ edge/level flags on DT booting

On 08/08/2014 06:38 PM, Javier Martinez Canillas wrote:
> It seems as if the first call to exynos_irq_set_type() that is made by OF is a
> no-op while the second call is the one that actually setups the hw correctly.
> Does this make any sense? Maybe is related to the pin not being muxed in the
> correct function when the "interrupts" property is parsed by OF?

So after a conversation with Tomasz Figa over IRC the problem was after all that
the pin was reconfigured. The IRQ trigger type resulted to be just a red herring
and not a direct cause.

The pinctrl-eyxnos driver does the IRQ pinmux setup in the .irq_set_type
function handler. So what happened was that OF parsed the "interrupts" property
and called exynos_irq_set_type() which did the pinmux setup.

But after that, due a DTS pinctrl configuration the pin function was changed as
a GPIO input and that happened before the atmel driver was probed. So when the
driver called request_threaded_irq(), the correct flags were used but the pin
was not configured as an IRQ anymore so IRQ were not fired.

Setting a trigger type just had the side effect of calling exynos_irq_set_type()
which again setup the pin as an IRQ.

To fix the issue a variation of patch [0] will be posted that moves the IRQ
pinmux setup from .irq_set_type to the .irq_request_resources function handler.
That way the pin will be setup as IRQ regardless of the the trigger type [1]
when someone calls request_[threaded]_irq().

Only the mentioned patch fixes the issue but Tomasz said that even a call to
gpio_direction_{input,output} can change the pin configuration so he will post
another patch that will add a bit mask to samsung_pin_bank to prevent any pinmux

Thanks a lot and best regards,


 \ /
  Last update: 2014-08-08 20:41    [W:0.054 / U:1.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site