Messages in this thread | | | From | Mattis Lorentzon <> | Subject | RE: Oops: 17 SMP ARM (v3.16-rc2) | Date | Wed, 27 Aug 2014 06:32:39 +0000 |
| |
Hi Iain, Russell and Fabio,
> The config is attached. Note that there's a lot of additional stuff enabled as > I'm aiming for a single general purpose kernel that covers i.MX6, AM3359, > Allwinner A10/A20 along with several versions of boards using those > particular SoCs. > > Same kernel binary on all the boards I've tried this on, only real differences > will be the devicetree and u-boot
Amazingly we have been able to run a complete nightly test on eight i.MX6 boards without hickups using Iain's config! We had to modify it slightly to get it to boot, please find attached patch and Iain's patched config.
On Russell's suggestion we also began to disable flow control on the machines. However it did not seem to make a difference because all our Zynq cards stalled during the same test run (using our own Zynq config).
Iain's config seems promising and we will continue to run tests during the next couple of days. We will also try to adapt Iain's config to our Zynq board.
Many thanks for all suggestions, patches and configs so far!
Best regards, Mattis Lorentzon
*************************************************************** Consider the environment before printing this message.
To read Autoliv's Information and Confidentiality Notice, follow this link: http://www.autoliv.com/disclaimer.html *************************************************************** [unhandled content-type:application/octet-stream][unhandled content-type:application/x-gzip] | |