lkml.org 
[lkml]   [2014]   [Aug]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 6/6] ARM: dts: Add tps65090 FETs constraints
On 08/12/2014 10:44 AM, Javier Martinez Canillas wrote:
> The tps65090 PMU data manual [0] has a table that list the
> "Recommended operating conditions" for each regulator. Add
> the information about the FET constraints to its dtsi file.
>
> [0]: http://www.ti.com/lit/ds/symlink/tps65090.pdf

I'm worried that this file represents the limits of the PMIC itself,
whereas the DT should be representing the limits of the circuits that
the various PMIC regulators are attached to on the board.

For example:

> diff --git a/arch/arm/boot/dts/tps65090.dtsi b/arch/arm/boot/dts/tps65090.dtsi

> tps65090_fet3: fet3 {
> + regulator-min-microvolt = <3000000>;
> + regulator-max-microvolt = <5500000>;
> };

I guess that on some boards, this output rail might be attached to
devices that must run at 3.3V exactly, and on other boards it might be
attached to devices that must run at 5V exactly. The DT for those two
boards should each have regulator-{min,max}-microvolt set to the same
value, which describes the board requirements.

It feels dangerous/misleading to define the PMIC range by default. It
might lead people to think that since the property already has a defined
value, they don't need to think about what the correct value for their
board is, and hence not change the value in their board file.


\
 
 \ /
  Last update: 2014-08-13 18:21    [W:0.498 / U:0.424 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site