lkml.org 
[lkml]   [2014]   [Aug]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH RFC 0/5] mmc: mmci: sdio related fixes
Date
From: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>

This patchset fixes few sdio related issues encountered while testing
WLAN ath6kl via SDIO on IFC6410 board with Qualcomm APQ8064 SOC.

First patch "mmc: mmci: Enable SDIO support for Qualcomm variant data"
enables sdio support for Qualcom SOCs. I can move this out of this series
if it make sense to do.

Patches "mmc: mmci: move block size validation under relevant code" and
"mmc: mmci: relax blksz check for SDIO"
relaxes error checks for blocksizes which are not exactly power of 2.
The issue was ath6kl driver was issuing 12 bytes and 24 bytes reads
which are caught as part of the error handing in the driver and
resulting in failures.

Patch "mmc: mmci: Add sdio enable mask in variant data" adds extra
variant parameter to enable sdio. This makes mmci driver more flexible.

Patch "mmc: mmci: move ST specific sdio setup under a condition"
move ST specific sdio setup under a vendor id check condition so that
other variants dont use it. Am happy to change this if there is any
other better way.

All these patches are tested on IFC6410 board with ath6kl WLAN via SDIO.

Thanks,
srini

Srinivas Kandagatla (5):
mmc: mmci: Enable SDIO support for Qualcomm variant data
mmc: mmci: move block size validation under relevant code
mmc: mmci: relax blksz check for SDIO
mmc: mmci: Add sdio enable mask in variant data
mmc: mmci: move ST specific sdio setup under a condition

drivers/mmc/host/mmci.c | 33 ++++++++++++++++++++-------------
1 file changed, 20 insertions(+), 13 deletions(-)

--
1.9.1



\
 
 \ /
  Last update: 2014-08-12 14:21    [W:0.345 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site