lkml.org 
[lkml]   [2014]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] extcon: max77693: Force using UART path for jig
Date
When USB cable is connected to jig, device disables console.
This patch forces using UART when jig cable is connected.
It allows to charge the device, which also prevents it from sleeping.

Signed-off-by: Dmitry Kasatkin <d.kasatkin@samsung.com>
Signed-off-by: Jonghwa Lee <jonghwa3.lee@samsung.com>
Signed-off-by: MyungJoo Ham <myungjoo.ham@samsung.com>
---
drivers/extcon/extcon-max77693.c | 14 +++++++++++---
1 file changed, 11 insertions(+), 3 deletions(-)

diff --git a/drivers/extcon/extcon-max77693.c b/drivers/extcon/extcon-max77693.c
index 1b194b3..862d68f 100644
--- a/drivers/extcon/extcon-max77693.c
+++ b/drivers/extcon/extcon-max77693.c
@@ -296,10 +296,18 @@ static int max77693_muic_set_path(struct max77693_muic_info *info,
return ret;
}

- if (attached)
- ctrl1 = val;
- else
+ if (attached) {
+ if (info->prev_cable_type ==
+ MAX77693_MUIC_ADC_FACTORY_MODE_UART_OFF) {
+ /* if cable_type is jig, then force UART */
+ dev_info(info->dev, "For jig force using UART path\n");
+ ctrl1 = CONTROL1_SW_UART;
+ } else {
+ ctrl1 = val;
+ }
+ } else {
ctrl1 = CONTROL1_SW_OPEN;
+ }

ret = max77693_update_reg(info->max77693->regmap_muic,
MAX77693_MUIC_REG_CTRL1, ctrl1, COMP_SW_MASK);
--
1.9.1


\
 
 \ /
  Last update: 2014-07-04 15:41    [W:0.055 / U:6.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site