lkml.org 
[lkml]   [2014]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 1/8] of: Add NVIDIA Tegra SATA controller binding
Hi,

On 07/16/2014 01:40 PM, Mikko Perttunen wrote:
> This patch adds device tree binding documentation for the SATA
> controller found on NVIDIA Tegra SoCs.
>
> Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
> ---
> v4: clarify mandatory clock order

Thanks this and the new v4 of "ata: Add support for the Tegra124 SATA controller"
both look good to me. So these 2 + v3 for the rest of the series are:

Acked-by: Hans de Goede <hdegoede@redhat.com>

Regards,

Hans



>
> .../devicetree/bindings/ata/tegra-sata.txt | 31 ++++++++++++++++++++++
> 1 file changed, 31 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/ata/tegra-sata.txt
>
> diff --git a/Documentation/devicetree/bindings/ata/tegra-sata.txt b/Documentation/devicetree/bindings/ata/tegra-sata.txt
> new file mode 100644
> index 0000000..de2f775
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/ata/tegra-sata.txt
> @@ -0,0 +1,31 @@
> +Tegra124 SoC SATA AHCI controller
> +
> +Required properties :
> +- compatible : "nvidia,tegra124-ahci".
> +- reg : Should contain 2 entries:
> + - AHCI register set (SATA BAR5)
> + - SATA register set
> +- interrupts : Defines the interrupt used by SATA
> +- clocks : Must contain an entry for each entry in clock-names.
> + See ../clocks/clock-bindings.txt for details.
> +- clock-names : Must include the following entries in the same
> + order as listed here:
> + - sata
> + - sata-oob
> + - cml1
> + - pll_e
> +- resets : Must contain an entry for each entry in reset-names.
> + See ../reset/reset.txt for details.
> +- reset-names : Must include the following entries:
> + - sata
> + - sata-oob
> + - sata-cold
> +- phys : Must contain an entry for each entry in phy-names.
> + See ../phy/phy-bindings.txt for details.
> +- phy-names : Must include the following entries:
> + - sata-phy : XUSB PADCTL SATA PHY
> +- hvdd-supply : Defines the SATA HVDD regulator
> +- vddio-supply : Defines the SATA VDDIO regulator
> +- avdd-supply : Defines the SATA AVDD regulator
> +- target-5v-supply : Defines the SATA 5V power regulator
> +- target-12v-supply : Defines the SATA 12V power regulator
>


\
 
 \ /
  Last update: 2014-07-16 14:21    [W:0.156 / U:0.384 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site