lkml.org 
[lkml]   [2014]   [Jun]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] regulator: palmas: Fix SMPS enable/disable/is_enabled
On Sat, Jun 21, 2014 at 2:26 AM, Nishanth Menon <nm@ti.com> wrote:
> We use regmap regulator ops to enable/disable and check if regulator
> is enabled for various SMPS. However, these depend on valid
> enable_reg, enable_mask and enable_value in regulator descriptor.
>
> Currently we do not populate these for SMPS other than SMPS10, this
> results in spurious results as regmap assumes that the values are
> valid and ends up reading register 0x0 RTC:SECONDS_REG on Palmas
> variants that do have RTC! To fix this, we update proper parameters
> for the descriptor fields.
>
> Further, we want to ensure the behavior consistent with logic
> prior to commit dbabd624d4eec50b6, where, once you do a set_mode,
> enable/disable ensure the logic remains consistent and configures
> Palmas to the configuration that we set with set_mode (since the
> configuration register is common). To do this, we can rely on the
> regulator core's regulator_register behavior where the regulator
> descriptor pointer provided by the regulator driver is stored. (no
> reallocation and copy is done). This lets us update the enable_value
> post registration, to remain consistent with the mode we configure as
> part of set_mode.

Tested-by: Alexandre Courbot <acourbot@nvidia.com>

Thanks!


\
 
 \ /
  Last update: 2014-06-21 06:41    [W:0.074 / U:1.668 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site