lkml.org 
[lkml]   [2014]   [May]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] bluetooth: raise HCI_CMD_TIMEOUT from 2s to 8s
Am 15.05.2014 17:19, schrieb Alexander Holler:
> Am 15.05.2014 16:50, schrieb Alexander Holler:
>> Am 15.05.2014 14:54, schrieb Luiz Augusto von Dentz:
>
>>> This timeout seems arbitrary so I suppose we can increase it if we
>>> feel it is necessary but we used already different timeout for
>>> different commands like HCI_POWER_OFF_TIMEOUT, so perhaps if we can
>>> identify which command is more likely to timeout.
>>>
>>> We could perhaps auto reset if a command timeout if there is really no
>>> other way to recover.
>>
>> It is arbitrary but 2s is not enough here. And as I've written in the
>> description, there is absolutely no reason to keep this timeout
>> unnecessarily short. No one cares if an error message appears after 2s
>> or 8s if the communication with the dongle is in both cases broken
>> afterwards.
>>
>> One of the commands I experieced the problem with was e.g.
>> HCI_OP_DELETE_STORED_LINK_KEY or HCI_OP_WRITE_SSP_MODE.
>
> The problem is that you can never be sure what the origin of a timeouted
> command was. It might have been e.g. the USB-subsystem through wich the
> command and the response has to travel (in case of USB dongles) and not
> the dongle itself.

To explain a bit more, the box I'm experiencing these problems boots
from USB2.0 HD. So it's likely that there is quiet some action on the
bus and that shouldn't affect the operation of the BT-stack (besides
slowing it maybe a bit down).

Regards,

Alexander Holler



\
 
 \ /
  Last update: 2014-05-16 08:21    [W:0.068 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site