lkml.org 
[lkml]   [2014]   [Apr]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Adding interrupt support to gpio-ich driver (possibly via SCI)
On Mon, Apr 07, 2014 at 08:21:00PM -0700, Guenter Roeck wrote:
> On 04/07/2014 07:48 PM, Matthew Garrett wrote:
> >You shouldn't need to install an SCI handler - the way the hardware will
> >generate an SCI is to raise a GPE. If you know which GPE the device
> >raises (my recollection is that for most Intel chipsets it's GPIO number
> >+ 0x10) then you can just call acpi_install_gpe_handler(). The problem
>
> Sounds good. Do you by any chance have a pointer to some documentation
> explaining this in some more detail ?

The SCI is just IRQ 9 - it tells the OS that there's a firmware event,
but in itself doesn't say what that event was. This is handled by the
platform setting bits in the GPE*_STS registers. The ACPI code reads
that and then dispatches the event to the appropriate handler. This will
typically be some ACPI code (declared by _Lxx and _Exx methods in the
ACPI tables - xx corresponds to the GPE number, L and E whether it's
level or edge triggered), but in some cases you want to install a
hardcoded event handler.

I've only got the 5-series docs to hand, and I can't remember whether
that's Panther Point, but you want to look at the definition of GPE0_STS
to figure out which hardware events cause which GPEs. GPEs 16 to 31
appear to correspond to GPIO 0 to 15, which is easy enough to handle.

> >is that the firmware may well already be using some of those GPIOs, and
> >there's no easy way to tell. Checking the interrupt configuration isn't
> >sufficient, since some of them may just be used as outputs.
> >
> The gpio-ich driver already has some magic to detect that condition - I
> noticed that I can not request all GPIO pins on all hardware. Either case,
> the gpio pins I am interested in are well defined on the hardware I am
> dealing with, so I can be sure I won't step on some unexpected use.

Ok. As long as you don't reprogram anything by default, I think this
should be fine.

--
Matthew Garrett | mjg59@srcf.ucam.org


\
 
 \ /
  Last update: 2014-04-08 06:21    [W:2.451 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site