lkml.org 
[lkml]   [2014]   [Apr]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] gpio: pl061: get gpio base from alias id
Hi Haojian Zhuang,

On Tue, Apr 22, 2014 at 09:35:42AM +0800, Haojian Zhuang wrote:
> If gpio base number isn't specified, the gpio base will be find from
> the end of gpio number. In order to keep with schematics, use alias
> to get the ID of gpio chip.
>
> Signed-off-by: Haojian Zhuang <haojian.zhuang@linaro.org>
> ---
> .../devicetree/bindings/gpio/gpio-pl061.txt | 31 ++++++++++++++++++++++

Binding documentation should be done in a separate patch.

> drivers/gpio/gpio-pl061.c | 14 +++++++++-
> 2 files changed, 44 insertions(+), 1 deletion(-)
> create mode 100644 Documentation/devicetree/bindings/gpio/gpio-pl061.txt
>
> diff --git a/Documentation/devicetree/bindings/gpio/gpio-pl061.txt b/Documentation/devicetree/bindings/gpio/gpio-pl061.txt
> new file mode 100644
> index 0000000..164b5ba
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/gpio-pl061.txt
> @@ -0,0 +1,31 @@
> +PL061 GPIO controller bindings
> +
> +Required properties:
> +- compatible:
> + - "arm,pl061", "arm,primecell".
> +- #gpio-cells : Should be two.
> + - first cell is the gpio pin number
> + - second cell is used to specify the gpio polarity:
> + 0 = active high
> + 1 = active low
> +- gpio-controller : Marks the device node as a GPIO controller.
> +- interrupt-controller : Marks the device node as an interrupt controller.
> +- #interrupt-cells : Should be two.
> + - first cell is the hw irq number
> + - second cell is used to specify the interrupt type:
> + 0 = default, unspecified type
> + 1 = rising edge triggered
> + 2 = falling edge triggered
> + 4 = high level triggered
> + 8 = low level triggered
> +
> +Example:
> + gpio0: gpio@fc806000 {
> + compatible = "arm,pl061", "arm,primecell";
> + reg = <0xfc806000 0x1000>;
> + interrupts = <0 64 0x4>;

The "interrupts" property should be mentioned above.

> + gpio-controller;
> + #gpio-cells = <2>;
> + interrupt-controller;
> + #interrupt-cells = <2>;
> + };

baruch

--
http://baruch.siach.name/blog/ ~. .~ Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
- baruch@tkos.co.il - tel: +972.2.679.5364, http://www.tkos.co.il -


\
 
 \ /
  Last update: 2014-04-22 06:01    [W:0.072 / U:1.844 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site