lkml.org 
[lkml]   [2014]   [Apr]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V2] i2c-designware: Mask all interrupts during i2c controller enable
Date
Hi all,

Updated problem descriptions from Mika's feedback and new test data:

There have been "i2c_designware 80860F41:00: controller timed out" errors
on a number of Baytrail platforms. The issue is caused by incorrect value in
Interrupt Mask Register (DW_IC_INTR_MASK) when i2c core is being enabled.
This causes call to __i2c_dw_enable() to immediately start the transfer which
leads to timeout. There are 3 failure modes observed:

1. Failure in S0 to S3 resume path

The default value after reset for DW_IC_INTR_MASK is 0x8ff. When we start
the first transaction after resuming from system sleep, TX_EMPTY interrupt
is already unmasked because of the hardware default.

2. Failure in normal operational path

This failure happens rarely and is hard to reproduce. Debug trace showed that
DW_IC_INTR_MASK had value of 0x254 when failure occurred, which meant
TX_EMPTY was unmasked.

2. Failure in S3 to S0 suspend path

This failure also happens rarely and is hard to reproduce. Adding debug trace
that read DW_IC_INTR_MASK made this failure not reproducible. But from ISR
call trace we could conclude TX_EMPTY was unmasked when problem occurred.


The patch masks all interrupts before the controller is enabled to resolve the
faulty DW_IC_INTR_MASK conditions.

Signed-off-by: Wenkai Du <wenkai.du@intel.com>
---
drivers/i2c/busses/i2c-designware-core.c | 3 +++
1 file changed, 3 insertions(+)

diff --git a/drivers/i2c/busses/i2c-designware-core.c b/drivers/i2c/busses/i2c-designware-core.c
index 14c4b30..71a3fa9 100644
--- a/drivers/i2c/busses/i2c-designware-core.c
+++ b/drivers/i2c/busses/i2c-designware-core.c
@@ -417,6 +417,9 @@ static void i2c_dw_xfer_init(struct dw_i2c_dev *dev)
*/
dw_writel(dev, msgs[dev->msg_write_idx].addr | ic_tar, DW_IC_TAR);

+ /* disable interrupts */
+ i2c_dw_disable_int(dev);
+
/* Enable the adapter */
__i2c_dw_enable(dev, true);

--
1.7.9.5


\
 
 \ /
  Last update: 2014-04-11 01:41    [W:0.070 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site