lkml.org 
[lkml]   [2014]   [Feb]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V3] net/dt: Add support for overriding phy configuration from device tree
2014-02-05 David Laight <David.Laight@aculab.com>:
> From: Florian Fainelli
>> It would be good to explain exactly how your hardware is broken
>> exactly. I really do not think that such a fine-grained setting where
>> you could disable, e.g: 100BaseT_Full, but allow 100BaseT_Half to
>> remain usable makes that much sense. In general, Gigabit might be
>> badly broken, but 100 and 10Mbits/sec should work fine. How about the
>> MASTER-SLAVE bit, is overriding it really required?
>
> There are plenty of systems out there where you'd want to disable
> either HDX or FDX modes.
> The MAC unit has to know whether the PHY is in HDX or FDX in order
> to work properly. Many do not need to know the speed - since the
> PHY is responsible for the tx/rx fifo clock.
> Getting the negotiated speed out of the PHY can be difficult, while
> the ANAR can easily be set.
> Unfortunately it is usually impossible to disable the 'fall-back'
> 10M HDX.

The problem that I have with that approach in general is that:

- it bloats the code for a set of properties that are going to be used
by hopefully a few percentage of the actual Device Trees out there
- it puts no limits on what is acceptable/best-practice to be put in
terms of configuration in the Device Tree, how about the 16x16 other
register values out there which are standardized?
- a PHY fixup should be registered based on the top-level compatible
property for a given board where the specific PHY on a specific board
is known to be broken
- make things incredibly harder to debug than they are today

I do acknowledge the need to have a solution to these problems, but
this seems to duplicate existing mechanisms available (e.g: PHY
fixups) without leveraging information that should be properly flagged
in the Device Tree (board model, root-node compatible string etc...)
to allow software to take corrective measures.
--
Florian


\
 
 \ /
  Last update: 2014-02-08 00:01    [W:0.166 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site