lkml.org 
[lkml]   [2014]   [Feb]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RESEND v10 3/4] PHY: add APM X-Gene SoC 15Gbps Multi-purpose PHY driver
On Thursday 27 February 2014 12:11 PM, Loc Ho wrote:
> Hi,
>
>>>>>>> +
>>>>>>> +static void sds_wr(void __iomem *csr_base, u32 indirect_cmd_reg,
>>>>>>> + u32 indirect_data_reg, u32 addr, u32 data)
>>>>>>> +{
>>>>>>> + u32 val;
>>>>>>> + u32 cmd;
>>>>>>> +
>>>>>>> + cmd = CFG_IND_WR_CMD_MASK | CFG_IND_CMD_DONE_MASK;
>>>>>>> + cmd = CFG_IND_ADDR_SET(cmd, addr);
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>> This looks hacky. If 'CFG_IND_WR_CMD_MASK | CFG_IND_CMD_DONE_MASK'
>>>>>> should
>>>>>> be set then it should be part of the second argument. From the macro
>>>>>> 'CFG_IND_ADDR_SET' the first argument should be more like the current
>>>>>> value
>>>>>> present in the register right? I feel the macro (CFG_IND_ADDR_SET) is
>>>>>> not
>>>>>> used in the way it is intended to.
>>>>>
>>>>>
>>>>>
>>>>> The macro XXX_SET is intended to update an field within the register.
>>>>> The update field is returned. The first assignment lines are setting
>>>>> another field. Those two lines can be written as:
>>>>>
>>>>> cmd = 0;
>>>>> cmd |= CFG_IND_WR_CMD_MASK; ==> Set the CMD bit
>>>>> cmd |= CFG_IND_CMD_DONE_MASK; ==> Set the DONE bit
>>>>> cmd = CFG_IND_ADDR_SET(cmd, addr); ===> Set the field ADDR
>>>>
>>>>
>>>>
>>>> #define CFG_IND_ADDR_SET(dst, src) \
>>>> (((dst) & ~0x003ffff0) | (((u32)(src)<<4) & 0x003ffff0))
>>>>
>>>> From this macro the first argument should be the present value in that
>>>> register. Here you reset the address bits and write the new address bits.
>>>
>>>
>>> Yes.. This is correct. I am clearing x number of bit and then set new
>>> value.
>>>
>>>> IMO the first argument should be the value in 'csr_base +
>>>> indirect_cmd_reg'.
>>>> So it resets the address bits in 'csr_base + indirect_cmd_reg' and write
>>>> down the new address bits.
>>>
>>>
>>> Yes.. The above code does just that. In addition, I am also setting
>>> the bits CFG_IND_WR_CMD_MASK and CFG_IND_CMD_DONE_MASK with the two
>>> previous statement. Think of the code flow as follow:
>>>
>>> val = readl(some void * address); /* read the register */
>>
>>
>> Where are you reading the register in your code (before CFG_IND_ADDR_SET)?
>
> I am not reading the register as I will be completely setting them.

Ok. Never-mind then. Sorry for the noise. You code is fine.

Thanks
Kishon


\
 
 \ /
  Last update: 2014-02-27 08:21    [W:0.048 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site