lkml.org 
[lkml]   [2014]   [Feb]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/3] mfd: twl6040: Updates for i2s speed and fix for chip deadlock
Date
Hi,

While looking into a report by Florian Vaussard [1] I have noticed couple of most
likely unrelated issues:
- all boards using twl6040 configures the i2c bus to 400KHz while twl6040 is set
to 100KHz as default.
- if I set the audpwron GPIO high [2] in the bootloader the i2c communication towards
twl6040 will be broken

The solution or these are:
set the twl6040 to i2c fast mode with regmap patch
Clear the INTID register right after we request the audpwron GPIO and set it to
low.

Generated on top of:
git://git.linaro.org/people/lee.jones/mfd.git for-mfd-next

Tested on PandaBoard, PandaBoardES, OMAP4-blaze (SDP)

[1] http://www.spinics.net/lists/arm-kernel/msg310725.html
[2] Command in u-boot to enable the audpwron on PandaBoards: gpio set 127

Regards,
Peter
---
Peter Ujfalusi (3):
mfd: twl6040: Select i2c fast mode as default with regmap patch
mfd: twl6040: Move register patching earlier in probe
mfd: twl6040: Clear the interrupt ID register before requesting IRQ

drivers/mfd/twl6040.c | 20 ++++++++++++++------
include/linux/mfd/twl6040.h | 1 +
2 files changed, 15 insertions(+), 6 deletions(-)

--
1.9.0



\
 
 \ /
  Last update: 2014-02-27 15:42    [W:0.118 / U:6.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site