lkml.org 
[lkml]   [2014]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH net-next 01/35] bnx2: Use pci_enable_msix_range() instead of pci_enable_msix()
On Sat, Feb 22, 2014 at 12:34:34AM +0000, Ben Hutchings wrote:
> > diff --git a/drivers/net/ethernet/broadcom/bnx2.c b/drivers/net/ethernet/broadcom/bnx2.c
> > index cda25ac..ca6b362 100644
> > --- a/drivers/net/ethernet/broadcom/bnx2.c
> > +++ b/drivers/net/ethernet/broadcom/bnx2.c
> > @@ -6206,7 +6206,7 @@ bnx2_free_irq(struct bnx2 *bp)
> > static void
> > bnx2_enable_msix(struct bnx2 *bp, int msix_vecs)
> > {
> > - int i, total_vecs, rc;
> > + int i, total_vecs;
> > struct msix_entry msix_ent[BNX2_MAX_MSIX_VEC];
> > struct net_device *dev = bp->dev;
> > const int len = sizeof(bp->irq_tbl[0].name);
> > @@ -6229,16 +6229,9 @@ bnx2_enable_msix(struct bnx2 *bp, int msix_vecs)
> > #ifdef BCM_CNIC
> > total_vecs++;
> > #endif
> > - rc = -ENOSPC;
> > - while (total_vecs >= BNX2_MIN_MSIX_VEC) {
> > - rc = pci_enable_msix(bp->pdev, msix_ent, total_vecs);
> > - if (rc <= 0)
> > - break;
> > - if (rc > 0)
> > - total_vecs = rc;
> > - }
> > -
> > - if (rc != 0)
> > + total_vecs = pci_enable_msix_range(bp->pdev, msix_ent,
> > + BNX2_MIN_MSIX_VEC, total_vecs);
> > + if (total_vecs < 0)
> > return;
>
> This would be better without the assignment to total_vecs.

total_vecs is used as a loop limit few lines below.

> Ben.
>
> > msix_vecs = total_vecs;
>
> --
> Ben Hutchings
> I haven't lost my mind; it's backed up on tape somewhere.



--
Regards,
Alexander Gordeev
agordeev@redhat.com


\
 
 \ /
  Last update: 2014-02-22 11:41    [W:1.212 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site