lkml.org 
[lkml]   [2014]   [Feb]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [Patch v5 1/2] dmaengine: add Qualcomm BAM dma driver
On Tue, Feb 11, 2014 at 11:49:10AM -0600, Josh Cartwright wrote:
> On Tue, Feb 11, 2014 at 11:00:48PM +0530, Vinod Koul wrote:
> > On Tue, Feb 04, 2014 at 02:42:35PM -0600, Andy Gross wrote:
> > > Add the DMA engine driver for the QCOM Bus Access Manager (BAM) DMA controller
> > > found in the MSM 8x74 platforms.
> > >
> > > Each BAM DMA device is associated with a specific on-chip peripheral. Each
> > > channel provides a uni-directional data transfer engine that is capable of
> > > transferring data between the peripheral and system memory (System mode), or
> > > between two peripherals (BAM2BAM).
> > >
> > > The initial release of this driver only supports slave transfers between
> > > peripherals and system memory.
> > >
> > > Signed-off-by: Andy Gross <agross@codeaurora.org>
> >
> > > +++ b/drivers/dma/qcom_bam_dma.c
> [..]
> > > +static void bam_reset_channel(struct bam_chan *bchan)
> > > +{
> > > + struct bam_device *bdev = bchan->bdev;
> > > +
> > > + /* reset channel */
> > > + writel_relaxed(1, bdev->regs + BAM_P_RST(bchan->id));
> > > + writel_relaxed(0, bdev->regs + BAM_P_RST(bchan->id));
> > > +
> > > + /* don't allow reorder of the channel reset */
> > > + wmb();
> > Documentation/memory-barriers.txt describes wmb() as a CPU barier but based on
> > above you want it to be a compiler barrier then you should do 1st write,
> > barrier(), second write.
>
> It could also be that the intent was to prevent these writes from being
> ordered before setting the initialized flag below, either way the
> comment could be made clearer.
yes for that case, but i am suspecting the comment is correct as it would make
sense to ensure reset is in sequence...

--
~Vinod
>
> > > +
> > > + /* make sure hw is initialized when channel is used the first time */
> > > + bchan->initialized = 0;
> > > +}
>
--


\
 
 \ /
  Last update: 2014-02-11 19:41    [W:0.078 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site