lkml.org 
[lkml]   [2014]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [Xen-devel] [PATCH v4 0/2] xen/pci: Use APIC for MSIs when APIC virtualization is supported
On 02/12/2014 20:48, Konrad Rzeszutek Wilk wrote:
> On Tue, Dec 02, 2014 at 03:19:11PM -0500, Boris Ostrovsky wrote:
>> Changes in v4:
>> * Added comment describing what we check for in pci_xen_init()
>>
> Reviewed-by: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>

Reviewed-by: Andrew Cooper <andrew.cooper3@citrix.com>

>
>> Changes in v3:
>> * Explicitly include asm/apic.h in arch/x86/pci/xen.c for !CONFIG_SMP.
>>
>> Changes in v2:
>> * New version of cpuid.h file from Xen tree (with a couple of style adjustments)
>> * Whitespace cleanup
>>
>> Currently HVM guests handle MSI interrupts using pirqs/event channels, allowing
>> us to not issue APIC accesses that result in somewhat expensive VMEXITs. When
>> hardware supports APIC virtualization we don't need to use pirqs anymore
>> since now guest's APIC accesses can be handled by the processor itself.
>>
>> There are two patches in this series:
>>
>> 1. Move setting of x86_msi ops to a later point. The reason for doing so is that
>> we currently decide whether or not to use pirqs before kernel had a chance to
>> see whether it should be using x2APIC instead of plain APIC. Since hardware may
>> virtualize either or both of those two we can only make pirqs vs. APIC selection
>> after kernel has settled down on which APIC version it will use. (Note that
>> currently x2APIC is not used by HVM guests so technically this patch is not
>> necessary. However, it probably makes sense to apply it now to avoid
>> forgetting to do it when we enable x2APIC).
>>
>> 2. Set x86_msi ops to use pirqs only when APIC virtualization is not available.
>> The commit message describes performance improvements that this change brings.
>>
>>
>> Boris Ostrovsky (2):
>> xen/pci: Defer initialization of MSI ops on HVM guests until after
>> x2APIC has been set up
>> xen/pci: Use APIC directly when APIC virtualization is supported by
>> hardware
>>
>> arch/x86/include/asm/xen/cpuid.h | 91 ++++++++++++++++++++++++++++++++++++++++
>> arch/x86/pci/xen.c | 31 +++++++++++++-
>> 2 files changed, 120 insertions(+), 2 deletions(-)
>> create mode 100644 arch/x86/include/asm/xen/cpuid.h
>>
>> --
>> 1.8.1.4
>>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@lists.xen.org
> http://lists.xen.org/xen-devel



\
 
 \ /
  Last update: 2014-12-03 02:01    [W:0.061 / U:0.588 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site