lkml.org 
[lkml]   [2014]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RFC v4 net-next 0/5] virtio_net: enabling tx interrupts
On Tue, Dec 02, 2014 at 05:08:35AM -0500, Pankaj Gupta wrote:
>
> >
> > On Tue, Dec 02, 2014 at 09:59:48AM +0008, Jason Wang wrote:
> > >
> > >
> > > On Tue, Dec 2, 2014 at 5:43 PM, Michael S. Tsirkin <mst@redhat.com> wrote:
> > > >On Tue, Dec 02, 2014 at 08:15:02AM +0008, Jason Wang wrote:
> > > >> On Tue, Dec 2, 2014 at 11:15 AM, Jason Wang <jasowang@redhat.com>
> > > >>wrote:
> > > >> >
> > > >> >
> > > >> >On Mon, Dec 1, 2014 at 6:42 PM, Michael S. Tsirkin <mst@redhat.com>
> > > >>wrote:
> > > >> >>On Mon, Dec 01, 2014 at 06:17:03PM +0800, Jason Wang wrote:
> > > >> >>> Hello:
> > > >> >>> We used to orphan packets before transmission for virtio-net. This
> > > >> >>>breaks
> > > >> >>> socket accounting and can lead serveral functions won't work, e.g:
> > > >> >>> - Byte Queue Limit depends on tx completion nofication to work.
> > > >> >>> - Packet Generator depends on tx completion nofication for the last
> > > >> >>> transmitted packet to complete.
> > > >> >>> - TCP Small Queue depends on proper accounting of sk_wmem_alloc to
> > > >> >>>work.
> > > >> >>> This series tries to solve the issue by enabling tx interrupts. To
> > > >> >>>minize
> > > >> >>> the performance impacts of this, several optimizations were used:
> > > >> >>> - In guest side, virtqueue_enable_cb_delayed() was used to delay
> > > >>the
> > > >> >>>tx
> > > >> >>> interrupt untile 3/4 pending packets were sent.
> > > >> >>> - In host side, interrupt coalescing were used to reduce tx
> > > >> >>>interrupts.
> > > >> >>> Performance test results[1] (tx-frames 16 tx-usecs 16) shows:
> > > >> >>> - For guest receiving. No obvious regression on throughput were
> > > >> >>> noticed. More cpu utilization were noticed in few cases.
> > > >> >>> - For guest transmission. Very huge improvement on througput for
> > > >> >>>small
> > > >> >>> packet transmission were noticed. This is expected since TSQ and
> > > >> >>>other
> > > >> >>> optimization for small packet transmission work after tx
> > > >>interrupt.
> > > >> >>>But
> > > >> >>> will use more cpu for large packets.
> > > >> >>> - For TCP_RR, regression (10% on transaction rate and cpu
> > > >> >>>utilization) were
> > > >> >>> found. Tx interrupt won't help but cause overhead in this case.
> > > >> >>>Using
> > > >> >>> more aggressive coalescing parameters may help to reduce the
> > > >> >>>regression.
> > > >> >>
> > > >> >>OK, you do have posted coalescing patches - does it help any?
> > > >> >
> > > >> >Helps a lot.
> > > >> >
> > > >> >For RX, it saves about 5% - 10% cpu. (reduce 60%-90% tx intrs)
> > > >> >For small packet TX, it increases 33% - 245% throughput. (reduce about
> > > >>60%
> > > >> >inters)
> > > >> >For TCP_RR, it increase the 3%-10% trans.rate. (reduce 40%-80% tx
> > > >>intrs)
> > > >> >
> > > >> >>
> > > >> >>I'm not sure the regression is due to interrupts.
> > > >> >>It would make sense for CPU but why would it
> > > >> >>hurt transaction rate?
> > > >> >
> > > >> >Anyway guest need to take some cycles to handle tx interrupts.
> > > >> >And transaction rate does increase if we coalesces more tx interurpts.
> > > >> >>
> > > >> >>
> > > >> >>It's possible that we are deferring kicks too much due to BQL.
> > > >> >>
> > > >> >>As an experiment: do we get any of it back if we do
> > > >> >>- if (kick || netif_xmit_stopped(txq))
> > > >> >>- virtqueue_kick(sq->vq);
> > > >> >>+ virtqueue_kick(sq->vq);
> > > >> >>?
> > > >> >
> > > >> >
> > > >> >I will try, but during TCP_RR, at most 1 packets were pending,
> > > >> >I suspect if BQL can help in this case.
> > > >> Looks like this helps a lot in multiple sessions of TCP_RR.
> > > >
> > > >so what's faster
> > > > BQL + kick each packet
> > > > no BQL
> > > >?
> > >
> > > Quick and manual tests (TCP_RR 64, TCP_STREAM 512) does not show obvious
> > > differences.
> > >
> > > May need a complete benchmark to see.
> >
> > Okay so going forward something like BQL + kick each packet
> > might be a good solution.
> > The advantage of BQL is that it works without GSO.
> > For example, now that we don't do UFO, you might
> > see significant gains with UDP.
>
> If I understand correctly, it can also help for small packet
> regr. in multiqueue scenario?

Well BQL generally should only be active for 1:1 mappings.

> Would be nice to see the perf. numbers
> with multi-queue for small packets streams.
> >
> >
> > > >
> > > >
> > > >> How about move the BQL patch out of this series?
> > > >> Let's first converge tx interrupt and then introduce it?
> > > >> (e.g with kicking after queuing X bytes?)
> > > >
> > > >Sounds good.
> > --
> > To unsubscribe from this list: send the line "unsubscribe netdev" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> >


\
 
 \ /
  Last update: 2014-12-02 11:41    [W:0.068 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site