lkml.org 
[lkml]   [2014]   [Dec]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 0/2] usb: serial: handle -ENODEV and -EPROTO quietly
On Mon, Dec 15, 2014 at 08:38:01AM -0800, Greg Kroah-Hartman wrote:
> On Mon, Dec 15, 2014 at 04:53:05AM -0800, Jeremiah Mahler wrote:
> > Johan,
> >
> > On Mon, Dec 15, 2014 at 11:23:21AM +0100, Johan Hovold wrote:
> > > On Thu, Dec 11, 2014 at 03:29:52PM -0800, Jeremiah Mahler wrote:
> > > > If a USB serial device (e.g. /dev/ttyUSB0) with an active program is
> > > > unplugged, a bunch of -ENODEV and -EPROTO errors will be produced in the
> > > > logs. This patch set quiets these messages without changing the
> > > > original behavior.
> > >
> > > Don't unplug devices that are in use then. ;)
> > >
> > I knew someone was going to say that :-)
> >
> > > > This change is beneficial when using daemons such as slcand, which is
> > > > similar to pppd or slip, that cannot determine whether they should exit
> > > > until after the USB serial device is unplugged. Producing these error
> > > > messages for a normal use case is not helpful.
> > >
> > > Your patches would hide these errors when they occur during normal use
> > > (e.g. EPROTO).
> > >
> > > Receiving an error message when unplugging an active device should not
> > > surprise anyone. And at least you know where it came from (and it's
> > > right there in the logs as well).
> > >
> > > Johan
> >
> > Hmm. Yes, I can see why quieting -EPROTO would be bad because it would
> > hide protocol errors which we want to know about.
>
> Do you really want to "know about" them? What can a user do with them?
> Nothing, so just resubmit and you should be fine.

Knowing that a device is flakey (and should be replaced) might be of
some worth?

And wouldn't silencing such errors mean that we could be quietly
dropping data?

> > I need to re-think this patch.
> > Nack.
>
> I like this patch, putting crud in the kernel log that no one can do
> anything with for a "normal" operation like yanking a USB device out
> while it is open should not happen.

The problem is that several errors may be returned from the
host-controller driver as a consequence of disconnect (before the hub
driver can process the disconnect). At least -EPROTO, -EILSEQ, -ETIME
are -EPIPE explicitly listed in Documentation/usb/error-codes.txt for
this, and of those, -EPROTO, -EILSEQ could also indicate hardware
problems.

I don't see how we can get around the trade-off between having a few
error messages in the log in the short window prior to a processed (and
also logged) disconnect, and not reporting potential hardware issues.

Thanks,
Johan


\
 
 \ /
  Last update: 2014-12-16 13:21    [W:0.069 / U:0.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site