[lkml]   [2014]   [Nov]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH] phy: omap-usb2: Enable runtime PM of omap-usb2 phy properly
From: Oussama Ghorbel <>

The USB OTG port does not work since v3.16 on omap platform.
This is a regression introduced by the commit
eb82a3d846fa (phy: omap-usb2: Balance pm_runtime_enable() on probe failure
and remove).
This because the call to pm_runtime_enable() function is moved after the
call to devm_phy_create() function, which has side effect since later in
the subsequent calls of devm_phy_create() there is a check with
pm_runtime_enabled() to configure few things.

Signed-off-by: Oussama Ghorbel <>
Tested-by: Rabin Vincent <>
Signed-off-by: Kishon Vijay Abraham I <>
drivers/phy/phy-omap-usb2.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/phy-omap-usb2.c b/drivers/phy/phy-omap-usb2.c
index 8c84298..f091576 100644
--- a/drivers/phy/phy-omap-usb2.c
+++ b/drivers/phy/phy-omap-usb2.c
@@ -258,14 +258,16 @@ static int omap_usb2_probe(struct platform_device *pdev)
otg->phy = &phy->phy;

platform_set_drvdata(pdev, phy);
+ pm_runtime_enable(phy->dev);

generic_phy = devm_phy_create(phy->dev, NULL, &ops, NULL);
- if (IS_ERR(generic_phy))
+ if (IS_ERR(generic_phy)) {
+ pm_runtime_disable(phy->dev);
return PTR_ERR(generic_phy);
+ }

phy_set_drvdata(generic_phy, phy);

- pm_runtime_enable(phy->dev);
phy_provider = devm_of_phy_provider_register(phy->dev,
if (IS_ERR(phy_provider)) {

 \ /
  Last update: 2014-11-04 07:41    [W:0.040 / U:3.108 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site