lkml.org 
[lkml]   [2014]   [Nov]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Subject[PATCH 0/6] ARM: sun9i: Add USB host controller support for A80
    Date
    Hi everyone,

    This series adds USB host controller (EHCI/OHCI) support for the Allwinner
    A80 SoC. The A80 has 3 pairs of host controllers and USB PHYs. The PHYs,
    unlike in previous SoCs, do not have low level control registers anymore.

    As such, this series forgoes the original phy-sun4i-usb driver, and adds
    a new, simpler driver for the USB PHYs. It may be possible to merge the
    two, but given that work is being done on the OTG front for the earlier
    SoCs, it may be better to merge them after support is complete.

    USB0 corresponds to USB1 DP/DM pins; USB1 only has HSIC support; USB2 is
    USB2 DP/DM externally. External pins labeled USB0 are for the USB 3.0 OTG
    controller.

    Patch 1 adds a80 specific support for usb-related clocks and resets.

    Patch 2 adds the device tree nodes for the usb clocks.

    Patch 3 adds a new generic phy driver for a80 usb phys. This has some
    code that is the same as the original phy-sun4i-usb driver, but is simpler.

    Patch 4 adds the 3 USB PHY nodes to the a80 dtsi.

    Patch 5 adds the USB host controller nodes to the a80 dtsi.

    Patch 6 adds the vbus regulator nodes and enables USB on the A80 Optimus
    board.


    Chen-Yu Tsai (6):
    clk: sunxi: Add support for sun9i a80 usb clocks and resets
    ARM: dts: sun9i: Add usb clock nodes to a80 dtsi
    phy: Add driver to support individual USB PHYs on sun9i
    ARM: dts: sun9i: Add usb phy nodes to a80 dtsi
    ARM: dts: sun9i: Add USB host controller nodes to a80 dtsi
    ARM: dts: sun9i: Enable USB support on A80 Optimus board

    Documentation/devicetree/bindings/clock/sunxi.txt | 5 +
    .../devicetree/bindings/phy/sun9i-usb-phy.txt | 34 +++
    arch/arm/boot/dts/sun9i-a80-optimus.dts | 72 +++++++
    arch/arm/boot/dts/sun9i-a80.dtsi | 129 ++++++++++++
    drivers/clk/sunxi/Makefile | 1 +
    drivers/clk/sunxi/clk-usb.c | 192 +++++++++++++++++
    drivers/phy/Kconfig | 12 ++
    drivers/phy/Makefile | 1 +
    drivers/phy/phy-sun9i-usb.c | 227 +++++++++++++++++++++
    9 files changed, 673 insertions(+)
    create mode 100644 Documentation/devicetree/bindings/phy/sun9i-usb-phy.txt
    create mode 100644 drivers/clk/sunxi/clk-usb.c
    create mode 100644 drivers/phy/phy-sun9i-usb.c

    --
    2.1.1



    \
     
     \ /
      Last update: 2014-11-04 05:41    [W:3.425 / U:0.356 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site