[lkml]   [2014]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] regulator: Ensure voltages are within the allowed range
On Wed, Nov 12, 2014 at 01:02:04PM +0100, Thierry Reding wrote:

> Perhaps rather than checking that the voltage is within the valid range
> we could at least cover the case where voltage is zero, which is what
> triggered me to write this patch.

Anything which has a voltage of zero is buggy anyway, zero volts is the
off state and should show up as such. If we don't have a voltage then
the enable should fail.

> Do you have any recommendations to work around this other than adjusting
> the actual voltage to be within the range?

Such regulators need a way of providing a bootsrapping voltage if
they're off when we start I think.
[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2014-11-12 16:21    [W:0.036 / U:12.644 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site